NDT - Non-Destructive Testing Visual Testing Fundamentals Questions and Answers

Question 1

An inspector is performing a direct visual examination of a weld on a pressure vessel. According to common NDT standards, what are the typical requirements for viewing distance and angle?

Accepted Answer

Within 24 inches and at an angle not less than 30 degrees.

Answer

Most NDT standards for direct visual testing, such as ASME Section V, Article 9, specify that the eye should be within 24 inches (600 mm) of the surface being examined and the viewing angle shall not be less than 30 degrees to the surface.

Question 2

Which of the following is a primary advantage of using a videoscope over a traditional fiberscope for remote visual inspection?

Accepted Answer

Videoscopes produce a higher resolution digital image that can be easily recorded and stored.

Answer

A key advantage of a videoscope is that it uses a miniature camera at the tip to capture a direct digital image, resulting in higher resolution and clarity. This digital format allows for easy recording, storage, and sharing of the inspection data. Fiberscopes transmit images through a bundle of optical fibers, which can result in lower resolution and are prone to damage (appearing as black dots).

Question 3

A visual inspector is examining a large, highly polished stainless steel surface and is having difficulty with severe glare, which is obscuring potential fine cracks. Which of the following actions would be MOST effective in mitigating the glare?

Accepted Answer

Changing the angle of the light source and/or the viewing angle.

Answer

Glare, or specular reflection, occurs when light reflects directly off a smooth surface into the inspector's eyes. The most effective way to reduce this is to change the geometry of the lighting and viewing setup. By adjusting the angle of the light source or the angle from which the surface is viewed, the direct reflection can be directed away from the eyes, allowing for a clearer view of the surface. Increasing direct light would worsen the glare.

Question 4

Which of the following human factors is most likely to negatively impact the reliability of a visual inspection by causing an inspector to misinterpret or fail to recognize a relevant indication?

Accepted Answer

Mental fatigue from long hours of inspection.

Answer

Mental fatigue has a significant negative impact on tasks requiring vigilance, like visual inspection. It can reduce an inspector's ability to process information accurately, leading them to miss indications or even see things that are not there. While other factors can play a role, fatigue is a critical human element affecting performance and reliability.

Question 5

An inspector is tasked with performing a visual inspection on the internal bore of a long, narrow pipe that is inaccessible by direct line of sight. Which of the following would be considered an indirect visual testing technique suitable for this task?

Accepted Answer

Employing a borescope to navigate and view the internal surface.

Answer

Indirect visual testing is used when direct line of sight is not possible. It involves using tools like borescopes, fiberscopes, or videoscopes to view the area of interest remotely. Using a mirror at the opening is a form of direct VT (aided), while calipers are for measurement, and penetrant testing is a different NDT method.

NDT - Non-Destructive Testing Practice Test

NDT - Non-Destructive Testing Practice Test

NDT - Non-Destructive Testing Visual Testing Fundamentals Questions and Answers