NDT - Non-Destructive Testing Magnetic Particle Testing Methods Questions and Answers

Question 1

An inspector is using the wet continuous method to perform a magnetic particle test on a steel weld. At which point should the application of the magnetic particles be stopped?

Accepted Answer

Just before the magnetizing current is turned off

Answer

In the wet continuous magnetization technique, the magnetic particle bath is applied to the part, and the flow is stopped just before the magnetizing current is turned off. This ensures that the particles are on the surface and mobile while the magnetic field is at its peak strength, providing maximum sensitivity for detecting discontinuities.

Question 2

Which of the following magnetization methods is most effective for detecting transverse discontinuities in a long, solid cylindrical bar?

Accepted Answer

Longitudinal magnetization using a coil

Answer

Longitudinal magnetization creates magnetic field lines that run parallel to the long axis of the bar. This orientation is perpendicular to transverse discontinuities, creating the strongest flux leakage and therefore the most detectable indications. A coil is the standard method for inducing a longitudinal field in this type of component.

Question 3

When inspecting a large casting with a rough surface for potential surface-breaking cracks, which magnetic particle testing method and particle type combination would be most suitable?

Accepted Answer

Dry powder method

Answer

The dry powder method is highly effective for inspecting rough surfaces, such as those on castings, because the larger particles are less likely to get trapped in minor surface irregularities, leading to fewer non-relevant indications. Wet methods can be less effective on very rough surfaces as the liquid carrier can pool and obscure indications.

Question 4

A technician is tasked with performing a magnetic particle inspection on a critical aerospace component made of a high-strength steel alloy. The procedure specifies using the residual method. This implies that the material must have:

Accepted Answer

High permeability and high retentivity

Answer

The residual method relies on the magnetism that remains in the part after the magnetizing force is removed. For this to be effective, the material must be easily magnetized (high permeability) and must retain a strong magnetic field (high retentivity) to create sufficient flux leakage at any discontinuities.

Question 5

Which of the following is a significant disadvantage of using the prod technique for inducing a circular magnetic field?

Accepted Answer

It has a high risk of causing arc strikes or localized overheating.

Answer

The prod technique involves passing a high amperage current directly through a localized area of the test piece via two handheld electrodes (prods). This creates a risk of arcing between the prods and the part surface, which can cause localized heating and metallurgical changes, potentially damaging the component.

NDT - Non-Destructive Testing Practice Test

NDT - Non-Destructive Testing Practice Test

NDT - Non-Destructive Testing Magnetic Particle Testing Methods Questions and Answers