IPAF Fall Protection and PPE 1

Question 1

What type of harness must be worn by operators when working inside an MEWP platform?

Accepted Answer

A full body harness with a dorsal or sternal attachment point

Answer

A full body harness with a dorsal or sternal attachment point is required to distribute arrest forces safely across the body.

Question 2

Where should an MEWP operator attach their lanyard when inside the work platform?

Accepted Answer

To the manufacturer-designated anchor point inside the platform

Answer

The lanyard must be attached to the manufacturer-designated anchor point inside the platform, which is designed and tested to withstand fall arrest loads.

Question 3

What is the primary function of a restraint lanyard when used in an MEWP?

Accepted Answer

To prevent the operator from reaching a position where a fall could occur

Answer

A restraint lanyard is set at a length that prevents the operator from reaching the platform edge, stopping them from falling in the first place.

Question 4

Which personal protective equipment item is mandatory for all MEWP operators under IPAF guidelines?

Accepted Answer

Full body harness and safety helmet as a minimum

Answer

IPAF guidelines mandate that all MEWP operators wear a full body harness and safety helmet as the minimum PPE requirement when working in a platform.

Question 5

Before starting work, when should an MEWP operator inspect their full body harness?

Accepted Answer

Before each use, as a pre-use inspection

Answer

A pre-use inspection before each use ensures any defects are identified before the harness is relied upon for fall protection.

IPAF PAL Card Practice Test

IPAF PAL Card Practice Test

IPAF Fall Protection and PPE 1