F60 Hot Work Area Safety 2

Question 1

Before torch operations begin, the fire guard must inspect the hot work area and ensure combustible materials are removed or protected within what minimum radius?

Accepted Answer

35 feet

Answer

FDNY regulations require combustible materials to be removed or protected within a 35-foot radius of the hot work area.

Question 2

During torch operations on a roof, the fire guard notices tar paper beneath the work area beginning to smolder. What is the FIRST action?

Accepted Answer

Stop work immediately and extinguish the smoldering material

Answer

Smoldering materials must be addressed immediately by stopping work and extinguishing the threat before it escalates.

Question 3

Which type of fire extinguisher is most appropriate for a hot work area where torch operations involve flammable gases?

Accepted Answer

Class B dry chemical extinguisher

Answer

Class B extinguishers are rated for flammable gas and liquid fires, which are the primary hazard during torch operations.

Question 4

A fire guard must remain on watch after torch operations cease. What is the required minimum watch period per FDNY regulations?

Accepted Answer

1 hour

Answer

FDNY requires the fire guard to maintain a 1-hour watch after hot work ends to detect any smoldering or delayed ignition.

Question 5

When torch operations must occur near a wooden structural element that cannot be removed, the fire guard should ensure the element is protected with:

Accepted Answer

Wet burlap or fire-resistant blankets

Answer

Wet burlap or fire-resistant blankets are approved protective coverings that shield combustible structures from torch heat and sparks.

(F60) Certificate of Fitness for Fire Guard for Torch Operations Practice Test

(F60) Certificate of Fitness for Fire Guard for Torch Operations Practice Test

F60 Hot Work Area Safety 2