F60 Torch Operation Safety Questions and Answers 1

Question 1

A Fire Guard is assigned to a torch operation where the operator is using oxygen and acetylene. Which of the following is a critical safety requirement for the gas cylinders?

Accepted Answer

They must be secured in an upright position.

Answer

Gas cylinders, especially acetylene, must be secured in an upright position. Acetylene cylinders contain a porous mass saturated with acetone to dissolve the acetylene, and a safety device that only functions correctly when the cylinder is upright. Laying them down could cause liquid acetone to be discharged, creating a dangerous situation.

Question 2

A Fire Guard is overseeing a torch operation in a designated hot work area. What is true about the permit requirements for this specific location?

Accepted Answer

The area is exempt from the daily permit requirement but must be inspected annually.

Answer

A designated hot work area is a permanent location designed and approved for hot work, which makes it exempt from the daily permit requirement. However, it must be inspected by the supervisor and responsible person at least annually to ensure it remains fire-safe.

Question 3

During a torch operation, sparks and slag might fall through a small floor opening to the level below. The area below contains combustible materials within 35 feet of the opening. What action is required by FDNY regulations?

Accepted Answer

An additional F-60 Fire Guard is required to conduct a fire watch on the floor below.

Answer

When torch operations are conducted near floor openings where sparks or slag could fall to a lower level, an additional F-60 Fire Guard is required. This second guard must be positioned on the floor below to watch for and extinguish any falling sparks that could ignite combustible materials.

Question 4

A torch operator holds a citywide permit and needs to begin work at a new location. What must the permit holder do before starting the operation?

Accepted Answer

Notify the building owner in writing at least 48 hours before work begins.

Answer

For any hot work operation conducted under a citywide permit, the permit holder is required to notify the owner of the premises in writing at least 48 hours before the work is scheduled to start. This ensures the property owner is aware and can designate a responsible person for the site.

Question 5

Which of the following conditions mandates the presence of an F-60 Fire Guard during torch operations?

Accepted Answer

When the operation is conducted on a construction site.

Answer

FDNY regulations specify three primary locations where a fire watch conducted by an F-60 fire guard is mandatory: 1) Construction sites, 2) Rooftops (especially with torch-applied roofing), and 3) Any building where the torch operator holds a citywide permit.

(F60) Certificate of Fitness for Fire Guard for Torch Operations Practice Test

(F60) Certificate of Fitness for Fire Guard for Torch Operations Practice Test

F60 Torch Operation Safety Questions and Answers 1