CWI Climbing Wall Safety & Equipment 3

Question 1

Which anchor configuration is considered best practice when setting up a top-rope at a climbing gym?

Accepted Answer

Two independent anchors equalized with a sliding X or masterpoint

Answer

Two independent equalized anchors create a redundant system that remains safe if one component fails.

Question 2

A belayer using an assisted-braking device like a Grigri should be trained to understand that the device:

Accepted Answer

Assists braking but does not replace the brake hand

Answer

Assisted-braking devices supplement but do not replace proper brake-hand technique; the belayer must always maintain a brake hand.

Question 3

What is the primary hazard associated with 'backclipping' a bolt on a lead climb?

Accepted Answer

The rope can unclip itself if the climber falls

Answer

When the rope runs back through a backclipped quickdraw, a fall can lever the gate open and unclip the rope.

Question 4

In the context of climbing wall safety, 'route setting' must account for:

Accepted Answer

Climber fall zones, swing potential, and proximity to other routes

Answer

Route setters must evaluate hazards including swing falls, ground fall potential, and interference with adjacent climbers or routes.

Question 5

A climbing instructor notices a student's figure-eight follow-through knot has the tail tied with only one inch of rope exiting the knot. The correct response is to:

Accepted Answer

Have the student retie with at least 4-6 inches of tail

Answer

A minimum 4-6 inch tail ensures the figure-eight cannot roll or creep loose under dynamic loading.

CWI Practice Test

CWI Practice Test

CWI Climbing Wall Safety & Equipment 3