CWI CWI Facility Management & Operations 2

Question 1

What is the recommended minimum frequency for rotating or resetting bouldering and top-rope routes in a commercial climbing gym to maintain member engagement?

Accepted Answer

Every 4–8 weeks depending on traffic volume and member feedback

Answer

Most commercial facilities rotate routes every 4–8 weeks to keep the experience fresh for regular members and prevent routes from becoming overly polished or outdated.

Question 2

A climber reports that a hold on a top-rope wall feels 'greasy' and spins slightly. What is the correct staff response?

Accepted Answer

Immediately pull the route from service, tighten or replace the hold, and verify the T-nut before reopening

Answer

A spinning hold is a safety hazard that could detach under load; the route must be closed and the hold secured before allowing further climbing.

Question 3

When planning the layout of a new climbing facility, what is the primary safety consideration for spacing between bouldering problems?

Accepted Answer

Providing adequate clearance to prevent climbers on adjacent problems from colliding mid-fall

Answer

Adequate spacing between bouldering problems is critical to prevent climbers falling from one problem from landing on or colliding with a climber on an adjacent problem.

Question 4

Under OSHA regulations, what is required when a climbing gym employee is working on elevated sections of a wall (e.g., during route setting above 4 feet)?

Accepted Answer

Fall protection systems such as a harness and belay, or a safety net, must be in use

Answer

OSHA General Industry standards require fall protection when working at heights above 4 feet, meaning route setters must use appropriate harness and belay systems or equivalent fall protection.

Question 5

Which of the following is the BEST practice for managing chalk buildup on climbing wall holds and panels?

Accepted Answer

Regularly brush holds with a stiff bristle brush and use compressed air to clean T-nut holes

Answer

Regular brushing with stiff bristle brushes removes chalk from holds while compressed air clears T-nut holes, preventing hardware corrosion and maintaining consistent friction properties.

CWI Practice Test

CWI Practice Test

CWI CWI Facility Management & Operations 2