QEI - Qualified Elevator Inspector Machine Room Procedures Questions and Answers

Question 1

A QEI performing a routine inspection of an elevator machine room notices that the lighting switch is located inside a locked closet adjacent to the machine room entrance. According to NEC 620.23, why is this a violation?

Accepted Answer

The lighting switch must be located at the point of entry to the machine room.

Answer

NEC (NFPA 70) Article 620.23 requires that the machine room lighting switch be located at the point of entry. This is to ensure that anyone entering the space can immediately illuminate it for safety before proceeding. Placing it in a separate closet violates this direct accessibility requirement.

Question 2

During a periodic inspection of a traction elevator, the QEI needs to verify the functionality of the governor. As part of the procedure, the inspector must confirm the presence and condition of the governor rope. According to ASME A17.1, which of the following is a critical requirement for the governor rope?

Accepted Answer

It must be of the size, material, and construction specified by the governor manufacturer.

Answer

ASME A17.1 Requirement 8.6.3.4.1 specifies that the governor rope must be of the same size, material, and construction as what the governor manufacturer originally specified. Using a different type of rope could affect the tripping characteristics of the governor, compromising its function as a critical safety device.

Question 3

A building owner informs a QEI that they wish to use the elevator machine room for general storage of building maintenance supplies to save space. Which of the following best explains why this is prohibited under standard safety codes?

Accepted Answer

Stored materials can obstruct access to disconnecting means and control panels.

Answer

ASME A17.1 and NEC Article 620 prohibit using machine rooms for storage of materials not related to the elevator equipment because such items can create fire hazards, obstruct clear working space around critical equipment, and block access to the main line disconnects needed for emergency and maintenance procedures.

Question 4

A QEI is inspecting a newly installed hydraulic elevator machine room. The inspector notes that the room is consistently at a temperature of 110°F (43°C) due to poor ventilation. According to ASME A17.1, what is the primary hazard associated with this condition?

Accepted Answer

It can lead to premature failure of solid-state electronic components in the controller.

Answer

ASME A17.1 requires that machine rooms be provided with ventilation to maintain a temperature range suitable for the elevator equipment. High ambient temperatures, often above 104°F (40°C), can cause overheating and premature failure of sensitive electronic components within the elevator controller, leading to unreliable operation and potential shutdowns.

Question 5

Before beginning a detailed inspection of the driving machine and controller, what is the first critical safety procedure a QEI must perform after ensuring no passengers are in the car?

Accepted Answer

Perform a Lockout/Tagout (LOTO) on the main line disconnect.

Answer

The first and most critical step before working on or near elevator machinery is to de-energize the equipment by performing a proper Lockout/Tagout (LOTO) procedure on the main line disconnect switch. This prevents the accidental startup of the equipment, which could cause severe injury or death.

QEI - Qualified Elevator Inspector Practice Test

QEI - Qualified Elevator Inspector Practice Test

QEI - Qualified Elevator Inspector Machine Room Procedures Questions and Answers