Certified Six Sigma Black Belt Exam FREE Certified Six Sigma Black Belt Measurement System Analysis (MSA) Questions and Answers 2

Question 1

In a Gage R&R study, what does 'reproducibility' specifically measure?

Accepted Answer

Variation due to different operators measuring the same part

Answer

Reproducibility quantifies the variation in measurements when different operators measure the same part using the same gage.

Question 2

A Gage R&R study shows that the %Study Variation for total Gage R&R is 35%. How should this measurement system be classified?

Accepted Answer

Unacceptable and requires improvement

Answer

A %Study Variation above 30% is generally considered unacceptable, indicating the measurement system contributes too much variation relative to process variation.

Question 3

What is the primary purpose of a linearity study in MSA?

Accepted Answer

To determine if measurement bias changes across the operating range of the gage

Answer

A linearity study evaluates whether the bias of a measurement system remains consistent across the full range of expected measurements.

Question 4

What is the minimum number of distinct categories (ndc) recommended by the AIAG for an acceptable measurement system?

Accepted Answer

5

Answer

The AIAG MSA manual recommends a minimum of 5 distinct categories to confirm the measurement system can adequately distinguish between parts.

Question 5

During an attribute agreement analysis, what does a kappa value of 0.41 to 0.60 indicate?

Accepted Answer

Moderate agreement

Answer

A kappa value between 0.41 and 0.60 is interpreted as moderate agreement according to the Landis and Koch benchmark scale.

Certified Six Sigma Black Belt Exam Practice Test

Certified Six Sigma Black Belt Exam Practice Test

Certified Six Sigma Black Belt Exam FREE Certified Six Sigma Black Belt Measurement System Analysis (MSA) Questions and Answers 2