Technical Measurements Flashcards
7 cards from real OSHA practice questions. Tap to flip, then mark Knew It or Still Learning — missed cards come back until you master them.
Read the first 7 Technical Measurements flashcards as text
A 10,000 lb load is lifted with a two-leg bridle at 60° from horizontal. What is the approximate tension in each leg?
Answer: 5,775 lb
Each leg carries 5,000 lb × 1.155 (the 60° load-angle factor) ≈ 5,775 lb.
An 8,000 lb load is rigged with a two-leg bridle at 45° from horizontal. What is the approximate tension per leg?
Answer: 5,656 lb
4,000 lb × 1.414 (the 45° factor) ≈ 5,656 lb per leg.
A 6,000 lb load is lifted with a two-leg bridle at 30° from horizontal. What is the tension in each leg?
Answer: 6,000 lb
At 30° the load-angle factor is 2.0, so each leg carries 3,000 × 2 = 6,000 lb.
Ignoring sheave friction, what is the line pull for a 30,000 lb load reeved with 6 parts of line?
Answer: 5,000 lb
Line pull = load ÷ parts of line = 30,000 ÷ 6 = 5,000 lb.
How should wire rope diameter be measured?
Answer: Across the crowns of opposite strands with a caliper
Correct rope diameter is the widest dimension, measured crown to crown with a caliper.
Under OSHA 1926.1413, a running wire rope diameter reduction of more than what percentage from nominal is a Category II deficiency?
Answer: 5%
OSHA lists a diameter reduction greater than 5% from nominal as a Category II wire rope deficiency.
A 1-inch-thick steel plate weighs about 40.8 lb per square foot. What does a 4 ft × 8 ft plate weigh?
Answer: 1,306 lb
32 ft² × 40.8 lb/ft² ≈ 1,306 lb.
Written and edited by Nathan Beja, founder of Practice Test Geeks, with AI assistance. Exam facts are checked against the official sources linked below. Editorial policy
Sources & references
Exam facts on this page (fees, format, dates, passing scores) are checked against these official sources; the date is our last check. Editorial policy