← All OSHA Flashcard Decks

Load Handling & Rigging Techniques Flashcards

7 cards from real OSHA practice questions. Tap to flip, then mark Knew It or Still Learning — missed cards come back until you master them.

Read the first 7 Load Handling & Rigging Techniques flashcards as text
  1. Under OSHA 29 CFR 1926.1413, a running wire rope (not rotation-resistant) must be removed from service when there are how many randomly distributed broken wires in one rope lay?

    Answer: Six

    Six randomly distributed broken wires in one lay, or three in one strand in one lay, is a removal criterion.

  2. Which of these conditions requires removing a synthetic web sling from service?

    Answer: Red warning core yarns are visible

    Visible red core yarns mean the outer fibers are worn through, so the sling must be removed from service.

  3. A plain-shank (non-shoulder) eyebolt should be loaded in what direction?

    Answer: Only in line with the shank (vertical)

    A plain-shank eyebolt can bend or snap under an angled load, so it should only take a vertical pull.

  4. Why is a softener placed between a sling and a sharp load edge?

    Answer: To protect the sling from cutting and to increase the bend radius

    Softeners prevent cutting damage and reduce the sharp bend that weakens slings, but they never raise the tag rating.

  5. What is a key difference between a spreader beam and a lifting beam?

    Answer: A spreader beam is loaded mainly in compression, while a lifting beam is loaded mainly in bending

    Angled top slings put a spreader beam in compression, while a lifting beam hangs from a single point and resists bending.

  6. Per ASME B30.10, a crane hook should be removed from service if it is twisted from its unbent plane by more than about how much?

    Answer: 10°

    Twist of more than 10° from the plane of the unbent hook is a removal criterion.

  7. How should a shackle be loaded for full rated capacity?

    Answer: In line with the shackle's centerline, with the pin fully engaged

    Rated capacity assumes an in-line load and a fully seated pin, and side loading reduces that capacity.

Written and edited by , founder of Practice Test Geeks, with AI assistance. Exam facts are checked against the official sources linked below. Editorial policy

Sources & references

Exam facts on this page (fees, format, dates, passing scores) are checked against these official sources; the date is our last check. Editorial policy

  1. osha.gov — Score validity · verified Nov 2026
  2. nccco.org — Test delivery, renewal, score release, eligibility, fees, exam format, time limit, score validity · verified Nov 2026