Home Inspector Test Ultimate Home Inspector 2

Question 1

When inspecting a crawl space, what minimum clearance height is generally required between the ground and the floor joists?

Accepted Answer

18 inches

Answer

Most building codes and inspection standards require at least 18 inches of clearance in crawl spaces to allow for adequate access and moisture management.

Question 2

A home inspector observes that the dryer vent terminates inside the attic. What is the primary concern with this installation?

Accepted Answer

It can cause moisture accumulation and mold growth

Answer

Dryer vents must terminate outside the building; venting into the attic deposits moisture and lint, creating ideal conditions for mold and a fire hazard.

Question 3

Which of the following window defects is considered a safety hazard in rooms used as sleeping areas?

Accepted Answer

Windows that do not open at least 5.7 square feet

Answer

Egress windows in sleeping rooms must provide a minimum 5.7 sq ft net clear opening so occupants can escape in an emergency.

Question 4

An inspector notes that a gas water heater in a garage is installed with its pilot and burner less than 18 inches above the floor. Why is this a concern?

Accepted Answer

Flammable vapors from vehicles accumulate near the floor and can ignite

Answer

Gasoline vapors from vehicles are heavier than air and pool at floor level; ignition sources must be elevated at least 18 inches to keep them above the vapor layer.

Question 5

What does the term 'flashing' refer to in the context of a home inspection?

Accepted Answer

Thin metal or membrane strips that direct water away from joints and penetrations

Answer

Flashing is sheet metal or membrane material installed at roof intersections, chimneys, skylights, and other penetrations to prevent water infiltration.

Home Inspector Test Practice Test

Home Inspector Test Practice Test

Home Inspector Test Ultimate Home Inspector 2