F80 Equipment Operation 4

Question 1

An operator notices the forklift pulls to one side during travel. What should they do?

Accepted Answer

Report the issue to a supervisor and remove the truck from service

Answer

Abnormal steering behavior indicates a mechanical problem that must be reported and the truck taken out of service immediately for inspection.

Question 2

What is the minimum safe following distance from another forklift while traveling?

Accepted Answer

Three truck lengths

Answer

OSHA recommends maintaining a following distance of approximately three truck lengths to allow enough stopping distance at typical travel speeds.

Question 3

LP gas cylinders on a forklift should be stored when not in use:

Accepted Answer

In a designated outdoor area or ventilated storage with the valve closed

Answer

LP cylinders must be stored in well-ventilated areas away from ignition sources, with valves closed, to prevent dangerous gas accumulation.

Question 4

When placing a load on a high shelf, an operator should:

Accepted Answer

Stop the forklift, then raise the load to the target height

Answer

Raising a load while moving dramatically increases instability; the forklift must be stopped before elevating loads to high positions.

Question 5

What is the correct procedure for refueling an LP-powered forklift?

Accepted Answer

Turn off the engine, change the cylinder in a ventilated area away from open flames

Answer

LP cylinder changes must be performed with the engine off in well-ventilated areas free of ignition sources to prevent fire or explosion.

F80 Practice Test