F80 Equipment Operation 4

Question 1

An operator notices the forklift pulls to one side during travel. What should they do?

Accepted Answer

Report the issue to a supervisor and remove the truck from service

Answer

Compensate by steering in the opposite direction and continue working

Answer

Reduce speed and finish the current task before reporting

Answer

Check tire pressure and adjust before the next shift

Question 2

What is the minimum safe following distance from another forklift while traveling?

Accepted Answer

Three truck lengths

Answer

One truck length

Answer

Two truck lengths

Answer

Five feet

Question 3

LP gas cylinders on a forklift should be stored when not in use:

Accepted Answer

In a designated outdoor area or ventilated storage with the valve closed

Answer

In the forklift's engine compartment

Answer

Indoors in a dedicated storage area away from heat sources

Answer

Horizontally on the ground to prevent tipping

Question 4

When placing a load on a high shelf, an operator should:

Accepted Answer

Stop the forklift, then raise the load to the target height

Answer

Raise the load to full height while moving toward the rack

Answer

Tilt the mast forward once the load clears the shelf

Answer

Increase engine speed to maintain hydraulic pressure while lifting

Question 5

What is the correct procedure for refueling an LP-powered forklift?

Accepted Answer

Turn off the engine, change the cylinder in a ventilated area away from open flames

Answer

Refuel with the engine running to save time during busy shifts

Answer

Refuel indoors only to protect the connection from wind

Answer

Keep the engine idling to maintain battery charge during the swap

Question 6

Which of the following is a hazard unique to electric forklifts compared to LP/diesel models?

Accepted Answer

Battery acid spills and hydrogen gas release during charging

Answer

Carbon monoxide emissions in enclosed spaces

Answer

Higher center of gravity due to engine weight

Answer

Greater difficulty stopping on wet surfaces

Question 7

A dock plate or dock board used to bridge a forklift from the dock to a trailer should be:

Accepted Answer

Rated for the combined weight of the forklift and its maximum load

Answer

Rated for at least the forklift's empty weight only

Answer

Secured only on the trailer side to allow flex

Answer

Inspected annually by a third-party engineer