F01 Out-of-Service System Tagging 3

Question 1

A contractor restores a sprinkler valve to the open position but forgets to remove the out-of-service tag. What problem does this create?

Accepted Answer

The building will continue to be treated as having an impaired system, potentially maintaining unnecessary fire watch costs and FDNY notification status

Answer

Leaving a tag on a restored component creates a false impairment status — the building will continue to operate as though the system is impaired, including unnecessary fire watch costs and FDNY impairment status.

Question 2

Which of the following scenarios would correctly trigger the placement of an out-of-service tag on a fire alarm device?

Accepted Answer

When a smoke detector is removed for cleaning or replacement during an impairment window

Answer

Removing a smoke detector for cleaning or replacement takes that device out of service. An out-of-service tag on the device location alerts personnel that detection in that area is temporarily compromised.

Question 3

When can an out-of-service tag be removed from a fire protection system component?

Accepted Answer

Only after the system is fully restored, operationally tested, and the impairment coordinator officially authorizes the tag removal

Answer

Tags may only be removed after: the component is physically restored, an operational test confirms the system is functioning correctly, and the impairment coordinator officially authorizes restoration and tag removal.

Question 4

An F-01 fireguard arrives to relieve an outgoing fireguard during a fire watch assignment. The outgoing fireguard states the impaired valve is 'somewhere on the 4th floor' but cannot show the fireguard the tagged component. What should the relieving fireguard do?

Accepted Answer

Require a physical walkthrough to locate and visually confirm the tagged out-of-service components before accepting the assignment

Answer

The relieving fireguard must physically verify the location of all out-of-service tagged components before accepting responsibility for the fire watch. A verbal description is not sufficient.

Question 5

What happens if a fire occurs in an area where a sprinkler valve is tagged out of service and FDNY discovers no fire watch was assigned?

Accepted Answer

The tag increases liability since it confirms the impairment was known but no compensatory measure was taken

Answer

An out-of-service tag documents that the impairment was known. Without an assigned fire watch, this constitutes a known unmitigated hazard, significantly increasing the building owner's legal liability.

(F01) NYC Fireguard F01 Certification Practice Test

(F01) NYC Fireguard F01 Certification Practice Test

F01 Out-of-Service System Tagging 3