CSWA Sweep and Loft Features 1

Question 1

What two elements are required at minimum to create a basic Sweep feature in SolidWorks?

Accepted Answer

A profile and a path

Answer

A sweep requires a profile sketch (cross-section) and a path sketch that the profile follows to create the swept geometry.

Question 2

In SolidWorks, a Loft feature creates geometry by:

Accepted Answer

Blending between two or more profiles

Answer

Loft blends between two or more profile sketches to create smooth transitions between different cross-sections.

Question 3

What is the minimum number of profiles required to create a Loft feature in SolidWorks?

Accepted Answer

2

Answer

A loft requires at least two profiles to define the start and end cross-sections of the blended shape.

Question 4

Which of the following can be used as a Sweep path in SolidWorks?

Accepted Answer

An open or closed sketch, or a set of model edges

Answer

A sweep path can be an open or closed sketch or a set of model edges, providing flexibility in defining the trajectory of the sweep.

Question 5

Guide curves in a Sweep feature are used to:

Accepted Answer

Control the orientation and shape of the profile along the path

Answer

Guide curves control how the profile cross-section changes orientation and shape as it travels along the sweep path.

CSWA - Certified Solidworks Associate Practice Test