CSWA Sweep and Loft Features 3

Question 1

What does the 'Keep Normal Constant' option do in a Sweep feature?

Accepted Answer

The profile maintains its original orientation relative to the world coordinate system

Answer

Keep Normal Constant maintains the profile's original orientation relative to the fixed world coordinate system rather than rotating to stay perpendicular to the path.

Question 2

To create a coil spring in SolidWorks, which combination of features is typically used?

Accepted Answer

Sweep with a circular profile and a helix as the path

Answer

A coil spring is created by sweeping a circular cross-section profile along a helix path, producing the characteristic helical coil geometry.

Question 3

Adding more intermediate profiles between the start and end of a Loft feature primarily controls:

Accepted Answer

The shape transitions along the loft between specified locations

Answer

Intermediate profiles give you additional control points to define exactly how the shape transitions along the length of the loft feature.

Question 4

In SolidWorks, a Swept Boss/Base feature is accessed through which menu path?

Accepted Answer

Insert > Features

Answer

Swept Boss/Base, along with other solid modeling features, is located under Insert > Features in the SolidWorks menu bar.

Question 5

When a point is used as one of the profiles in a Loft feature, what is the result?

Accepted Answer

The loft creates a tapered end that converges to that point

Answer

Using a point as a loft profile creates a tapered termination where the geometry converges to that single location, useful for cone-like or sharp-tipped geometry.

CSWA - Certified Solidworks Associate Practice Test

CSWA - Certified Solidworks Associate Practice Test

CSWA Sweep and Loft Features 3