CSWA Sweep and Loft Features 3

Question 1

What does the 'Keep Normal Constant' option do in a Sweep feature?

Accepted Answer

The profile maintains its original orientation relative to the world coordinate system

Answer

The profile remains perpendicular to the path at all times

Answer

The profile follows both the path and guide curves simultaneously

Answer

The profile rotates by a specified twist angle along the path

Question 2

To create a coil spring in SolidWorks, which combination of features is typically used?

Accepted Answer

Sweep with a circular profile and a helix as the path

Answer

Extrude Boss followed by a Shell feature

Answer

Loft with multiple circular profiles stacked vertically

Answer

Revolve with a rectangular profile around a center axis

Question 3

Adding more intermediate profiles between the start and end of a Loft feature primarily controls:

Accepted Answer

The shape transitions along the loft between specified locations

Answer

The overall length of the loft feature

Answer

The surface finish and smoothness quality of the loft faces

Answer

The material and mass properties assigned to the loft

Question 4

In SolidWorks, a Swept Boss/Base feature is accessed through which menu path?

Accepted Answer

Insert > Features

Answer

Insert > Surface

Answer

Edit > Boss

Answer

Tools > Features

Question 5

When a point is used as one of the profiles in a Loft feature, what is the result?

Accepted Answer

The loft creates a tapered end that converges to that point

Answer

The loft fails to generate and shows an error

Answer

The loft treats the point as a small circular profile

Answer

The loft skips the point and transitions to the next full profile

Question 6

The 'Align with end faces' option in a Sweep feature is useful because it:

Accepted Answer

Adjusts the sweep termination to match the angle of the bounding model faces

Answer

Forces the profile to align with a specific reference plane

Answer

Snaps the path endpoint to the nearest model edge

Answer

Causes the profile to rotate to face the end faces during the sweep

Question 7

Which of the following statements about Loft profiles in SolidWorks is TRUE?

Accepted Answer

Profiles can be on non-parallel planes and even defined as 3D sketches

Answer

All profiles must be located on parallel planes

Answer

All profiles must contain the same number of sketch segments

Answer

All profiles must be the same shape but scaled to different sizes