CRFSC - Canadian Restricted and Non-Restricted Firearm Safety Operating Firearm Actions Questions and Answers

Question 1

When operating a single-action revolver, what is the critical step that must be performed by the shooter before each shot can be fired?

Accepted Answer

Manually cocking the hammer.

Answer

In a single-action firearm, the trigger's only function is to release the hammer. Therefore, the shooter must manually pull the hammer back (cock it) before each shot. This is different from a double-action, where pulling the trigger performs both the cocking and releasing of the hammer.

Question 2

A shooter is at the range with a double-action semi-automatic pistol. After inserting a loaded magazine and chambering a round, the hammer is cocked. The shooter decides not to fire and wants to make the firearm safer. Which action is the most appropriate next step?

Accepted Answer

Use the de-cocking lever or safety/de-cocking lever, if available.

Answer

Modern double-action semi-automatic pistols are often equipped with a de-cocking lever or a combination safety/de-cocking lever. This mechanism is the safest way to lower the cocked hammer without pulling the trigger, which could cause an accidental discharge. Manually lowering the hammer while pulling the trigger is an advanced technique that carries a high risk of slipping and causing the gun to fire.

Question 3

Which of the following firearm actions requires the operator to slide the fore-end towards them and then away to eject a spent cartridge and chamber a new one?

Accepted Answer

Pump-action

Answer

The defining characteristic of a pump-action firearm (commonly shotguns and some rifles) is the moveable fore-end that is manually slid back and forth along the barrel to cycle the action.

Question 4

When performing the 'PROVE' procedure on a semi-automatic pistol, what is the correct sequence of actions after pointing the firearm in a safe direction?

Accepted Answer

Remove the magazine, Lock the action open, Observe the chamber, Verify the feeding path, Examine the bore.

Answer

The correct PROVE sequence for a semi-automatic pistol is: Point in a safe direction, Remove all ammunition (which starts with removing the magazine), Observe the chamber, Verify the feeding path, and Examine the bore. Removing the magazine first is a critical step to ensure no new cartridges can be fed into the chamber.

Question 5

In a double-action revolver, a single, continuous pull of the trigger will perform which two functions?

Accepted Answer

Cock the hammer and then release it to fire.

Answer

The term 'double-action' refers to the trigger performing two actions: cocking the hammer and then releasing it to strike the primer and fire the cartridge. This allows the revolver to be fired without manually cocking the hammer first.

CRFSC - Canadian Restricted and Non-Restricted Firearm Safety Practice Test

CRFSC - Canadian Restricted and Non-Restricted Firearm Safety Practice Test

CRFSC - Canadian Restricted and Non-Restricted Firearm Safety Operating Firearm Actions Questions and Answers