CPCS Telescopic Handler 2

Question 1

Under LOLER 1998, how often must a telehandler's lifting accessories (slings, shackles, chains) be thoroughly examined?

Accepted Answer

Every 12 months, or every 6 months if used for lifting persons

Answer

Under LOLER 1998, lifting accessories must be thoroughly examined by a competent person at least every 6 months. The telehandler itself as lifting equipment must be examined every 12 months, or every 6 months if used for lifting persons.

Question 2

What hazard is specific to a telehandler fitted with a personnel work platform (man basket)?

Accepted Answer

Risk of persons falling from height if the platform is not properly secured

Answer

Using a personnel platform on a telehandler introduces significant fall-from-height risks. The platform must be purpose-designed, properly attached, and the telehandler must be rated for personnel lifting. LOLER requires 6-monthly thorough examination when lifting persons.

Question 3

What should the operator check about the ground before deploying a telehandler's stabilisers?

Accepted Answer

That the ground is firm enough to support the stabiliser loads and suitable packing is used

Answer

Before deploying stabilisers, the operator must ensure the ground can support the concentrated point loads from the stabiliser pads. Suitable timber or steel packing should be used to spread the load. Soft, waterlogged, or recently backfilled ground may not be adequate.

Question 4

When a telehandler is operating as a crane (lifting freely suspended loads), what additional regulations apply beyond PUWER?

Accepted Answer

LOLER 1998 — Lifting Operations and Lifting Equipment Regulations

Answer

When a telehandler lifts freely suspended loads (acting as a crane), it falls under LOLER 1998 in addition to PUWER 1998. This means a lift plan is required, the machine needs thorough examination as lifting equipment, and an Appointed Person must oversee the operation.

Question 5

What is the danger of turning a telehandler sharply at speed while carrying a raised load?

Accepted Answer

The machine can overturn due to centrifugal force raising the centre of gravity

Answer

Sharp turning at speed with a raised load creates centrifugal force that acts to tip the machine sideways. Combined with the already raised centre of gravity from the elevated load, this can cause the telehandler to overturn laterally, which is frequently fatal.

CPCS Theory Practice Test

CPCS Theory Practice Test

CPCS Telescopic Handler 2