Rope Access Safety & Procedures Flashcards

A technician is moving between two separately anchored rope systems at height. What is this maneuver called?

Answer: Rope-to-rope transfer

A rope-to-rope transfer moves the technician from one rope system to another while staying attached.

What is the main hazard of an unsupervised Level I technician rigging anchors alone?

Answer: Rigging errors may go unchecked because Level I is not qualified to rig unsupervised

Level I technicians work under supervision, and rigging must be done or checked by qualified higher-level technicians.

Why should anchor slings be checked where they wrap around a structural member?

Answer: Sharp edges or hot surfaces can cut or damage the sling

Contact points can abrade, cut or heat-damage slings, so protection or padding may be needed.

During a pick-off rescue, what is the rescuer's first priority?

Answer: Their own safety and secure attachment

A rescuer must remain safe and properly attached, or there may be two casualties.

A rebelay is used to do what?

Answer: Re-anchor the rope partway down to avoid an edge or rub point

A rebelay is an intermediate anchor that keeps the rope away from abrasion and splits the rope into sections.

How often must a SPRAT certification be renewed?

Answer: Every 3 years

SPRAT certifications are valid for three years before recertification is required.

Which item belongs in a daily pre-use equipment inspection?

Answer: Inspecting harness webbing, stitching and buckles for damage

Harness webbing, stitching and hardware must be checked for cuts, wear or deformation before each use.