Ramsay Test Print Reading and Schematics 3

Question 1

What does the abbreviation 'TYP' on a print indicate?

Accepted Answer

The feature is typical and repeats at similar locations

Answer

TYP means 'typical,' so the noted dimension applies to all similar features.

Question 2

In an orthographic projection drawing, the three standard views shown are normally which?

Accepted Answer

Front, top, and right side

Answer

Third-angle orthographic drawings typically show front, top, and right-side views.

Question 3

A cutting-plane line on a drawing is used to indicate what?

Accepted Answer

Where a section view is taken through the part

Answer

The cutting-plane line shows the location and direction of a section cut.

Question 4

In a hydraulic schematic, a circle with a triangle pointing outward generally represents what component?

Accepted Answer

A pump

Answer

A circle with an outward-pointing triangle is the standard symbol for a hydraulic pump.

Question 5

Cross-hatching (diagonal lines) in a section view represents what?

Accepted Answer

The solid material that was cut through

Answer

Section lines (cross-hatch) fill the areas of solid material exposed by the cut.

Ramsay Test Practice Test