Ramsay Test Print Reading and Schematics 3

Question 1

What does the abbreviation 'TYP' on a print indicate?

Accepted Answer

The feature is typical and repeats at similar locations

Answer

The feature is a tapped hole

Answer

The dimension is a tolerance

Answer

The view is a top view

Question 2

In an orthographic projection drawing, the three standard views shown are normally which?

Accepted Answer

Front, top, and right side

Answer

Front, back, and bottom

Answer

Isometric, top, and section

Answer

Left, right, and rear

Question 3

A cutting-plane line on a drawing is used to indicate what?

Accepted Answer

Where a section view is taken through the part

Answer

The outer boundary of the part

Answer

A hidden internal thread

Answer

The center of a bolt circle

Question 4

In a hydraulic schematic, a circle with a triangle pointing outward generally represents what component?

Accepted Answer

A pump

Answer

A check valve

Answer

A reservoir

Answer

A pressure gauge

Question 5

Cross-hatching (diagonal lines) in a section view represents what?

Accepted Answer

The solid material that was cut through

Answer

Empty space inside the part

Answer

A welded joint

Answer

A surface finish callout

Question 6

What does a leader line do on a drawing?

Accepted Answer

Connects a note or dimension to a specific feature

Answer

Shows the centerline of a part

Answer

Marks a hidden edge

Answer

Indicates the scale of the drawing

Question 7

On an electrical schematic, a zigzag line or rectangle symbol typically represents which component?

Accepted Answer

A resistor

Answer

A capacitor

Answer

A battery

Answer

A switch