Ramsay Test Hand and Power Tools

Question 1

When using a click-type torque wrench to tighten a fastener, the technician should:

Accepted Answer

Apply smooth, steady force and stop immediately when the wrench clicks

Answer

Apply force in short jerky strokes to ensure the click registers

Answer

Continue tightening one-quarter turn after the click to ensure full seating

Answer

Use the torque wrench to break the fastener loose before torquing to spec

Question 2

Before mounting an abrasive wheel on an angle grinder, the most critical safety check is:

Accepted Answer

Ensuring the wheel's maximum RPM rating meets or exceeds the grinder's no-load speed

Answer

Confirming the wheel is the same color as the previous wheel

Answer

Removing the guard to verify the wheel seats flush on the flange

Answer

Soaking the wheel in water to prevent overheating during use

Question 3

A mechanic needs a clean, square cut on a 1.5-inch steel pipe. The most appropriate tool is:

Accepted Answer

A pipe (tubing) cutter

Answer

A hacksaw with a 14 TPI blade

Answer

A reciprocating saw with a wood blade

Answer

An oxyacetylene cutting torch

Question 4

Before drilling a hole in a metal workpiece, a center punch is used to:

Accepted Answer

Create a small indentation that prevents the drill bit from walking off location

Answer

Deburr the hole after drilling is complete

Answer

Harden the metal at the drill point to improve bit life

Answer

Mark the metal with a visible paint impression for layout

Question 5

When selecting a Phillips screwdriver, using a tip that is too small for the screw head primarily causes:

Accepted Answer

Cam-out — the tip riding up and out of the recess under torque

Answer

The screw to strip its thread due to excess torque

Answer

The screw head to crack from stress concentration

Answer

No problem, since a smaller tip fits inside a larger recess

Question 6

When tapping a blind hole (a hole that does not pass through the workpiece), the correct sequence of taps to use is:

Accepted Answer

Taper tap first, then plug tap, then bottoming tap to finish near the bottom

Answer

Bottoming tap only — it cuts to the bottom in one pass

Answer

Plug tap only — it has enough chamfer for all holes

Answer

Bottoming tap first to set the depth, then taper tap to cut the threads