FREE Licensed Electrical Contractor Safety and OSHA Regulations Questions and Answers

Question 1

An electrician must replace a motor starter in a control panel. The main disconnect for the panel is 50 feet away and not in the line of sight. According to OSHA's Lockout/Tagout standard (29 CFR 1910.147), what is the first and most critical action the electrician must take?

Accepted Answer

De-energize the panel, then apply a personal lock and tag to the main disconnect.

Answer

OSHA's Lockout/Tagout (LOTO) standard requires the authorized employee to first isolate the equipment from the energy source and then affix a personal lock and tag to the isolating device. This ensures the equipment cannot be unexpectedly re-energized. Testing for the absence of voltage is a verification step performed *after* the lock is applied. Notifying a supervisor is a good administrative step but not the primary control measure. A tag on the starter itself does not control the energy source.

Question 2

An arc flash hazard analysis determines that an electrician must wear Category 2 PPE to work on energized 480V switchgear. Which of the following collections of PPE best meets the minimum requirements for this category as defined by NFPA 70E?

Accepted Answer

Arc-rated clothing (e.g., shirt and pants or coverall), an arc-rated face shield with a balaclava/sock hood, and a hard hat.

Answer

NFPA 70E specifies the PPE for each Arc Flash PPE Category. Category 2 requires arc-rated clothing with a minimum arc rating of 8 cal/cm², along with an arc-rated face shield and balaclava (or an arc-rated hood), a hard hat, safety glasses, and hearing protection. A full arc flash suit is typically for Category 3 or 4. Leather gloves and safety glasses alone are insufficient, and standard cotton clothing is flammable and prohibited.

Question 3

A contractor on a construction site opts to use an Assured Equipment Grounding Conductor Program (AEGCP) instead of GFCIs for temporary 120-volt receptacle outlets. Which of the following is a mandatory component of this OSHA-compliant program?

Accepted Answer

A written description of the program must be kept at the jobsite and be available to OSHA.

Answer

According to OSHA 29 CFR 1926.404(b)(1)(iii), an AEGCP requires several specific actions, including maintaining a written description of the program at the jobsite for inspection. The program also requires daily visual inspections of cord sets and continuity/polarity tests at least every 3 months, not monthly or semi-annually.

Question 4

An electrician uses a 24-foot extension ladder to access a junction box on a building wall. The point of contact with the wall is 18 feet above the ground. According to OSHA safety regulations (29 CFR 1926 Subpart X), what is the minimum distance the side rails of the ladder must extend above the roofline or landing surface?

Accepted Answer

3 feet

Answer

OSHA standard 29 CFR 1926.1053(b)(1) mandates that when portable ladders are used to access an upper landing surface, the ladder's side rails must extend at least 3 feet above that surface. This ensures a worker has a secure point to hold onto while transitioning from the ladder to the landing.

Question 5

According to OSHA and NFPA 70E standards, working on energized electrical equipment is generally prohibited. Under which of the following conditions is performing energized work most likely to be justified?

Accepted Answer

The task involves troubleshooting or diagnostics that are impossible to perform on a de-energized circuit.

Answer

OSHA and NFPA 70E permit energized work only when it is infeasible due to equipment design or operational limitations, or if de-energizing would introduce additional hazards. Troubleshooting and taking diagnostic measurements often require the circuit to be energized and are recognized as a valid justification. Inconvenience, client preference, and lack of proper safety equipment are never acceptable reasons to perform energized work.

Licensed Electrical Contractor Practice Test

Licensed Electrical Contractor Practice Test

FREE Licensed Electrical Contractor Safety and OSHA Regulations Questions and Answers