FREE 313D Electrical Schematics and Controls Questions and Answers

Question 1

On a residential air conditioning schematic, what is the function of a contactor?

Accepted Answer

To use a low-voltage signal to switch the high-voltage power to the compressor and condenser fan motor.

Answer

A contactor is an electrically controlled switch, similar to a relay but built for higher current loads. In an AC system, the 24-volt signal from the thermostat energizes the contactor's coil, which closes a set of high-voltage contacts, allowing line voltage (e.g., 240V) to power the compressor and condenser fan motor.

Question 2

A technician is troubleshooting a system where the indoor fan runs continuously, but the outdoor unit never starts. A multimeter shows 24V at the thermostat's 'Y' terminal when calling for cooling, but the contactor coil is not energized. Which of the following is the MOST likely cause?

Accepted Answer

A tripped high-pressure safety switch.

Answer

The 24V signal from the 'Y' terminal travels in series through safety switches, such as high and low-pressure switches, before reaching the contactor coil. If a safety switch is open (tripped), it will interrupt the circuit, preventing the contactor from energizing and starting the outdoor unit.

Question 3

While examining a wiring diagram, you see a symbol representing a switch that is held open by a spring and closes when a magnetic field is created by a coil. This symbol most likely represents which of the following components?

Accepted Answer

A normally open (NO) relay.

Answer

This describes the basic operation of a normally open (NO) relay or contactor. In its resting state, the contacts are open. When the coil is energized with a control voltage, it creates a magnetic field that pulls the contacts closed, completing a separate circuit.

Question 4

A technician is diagnosing a no-cool situation. The thermostat is calling for cooling, and the low-voltage fuse on the indoor unit's control board is blown. What is a common cause for this issue?

Accepted Answer

A short circuit in the low-voltage wiring between the indoor and outdoor units.

Answer

A blown low-voltage fuse indicates an overcurrent condition in the control circuit. This is frequently caused by a short to ground, where a low-voltage wire (like the 'Y' or 'C' wire) has its insulation damaged and is touching the chassis or another wire, creating a direct path for current to flow, which blows the protective fuse.

Question 5

In a residential AC electrical schematic, which component is responsible for protecting the compressor from damage if there is a refrigerant leak causing suction pressure to drop to an unsafe level?

Accepted Answer

The low-pressure switch.

Answer

The low-pressure switch is a safety device installed on the suction side of the system. If the refrigerant pressure drops below a preset limit, which can happen during a leak, the switch opens the control circuit to the compressor contactor, shutting it down to prevent damage from running without sufficient refrigerant.

(313D) Residential Air Conditioning Systems Mechanic Certification Practice Test

(313D) Residential Air Conditioning Systems Mechanic Certification Practice Test

FREE 313D Electrical Schematics and Controls Questions and Answers