NOCE Optical Instrumentation Usage Questions and Answers

Question 1

An optician is using a manual keratometer to measure the corneal curvature of a patient. The horizontal meridian reading is 44.50 D and the vertical meridian reading is 42.75 D. What does this finding indicate?

Accepted Answer

Against-the-rule astigmatism

Answer

Against-the-rule astigmatism is present when the horizontal meridian of the cornea is steeper (has a higher dioptric power) than the vertical meridian. In this case, the horizontal reading of 44.50 D is steeper than the vertical reading of 42.75 D.

Question 2

When using a digital pupillometer to take a monocular pupillary distance (PD) measurement for progressive lenses, the optician should instruct the patient to fixate on:

Accepted Answer

The light source within the instrument

Answer

A digital pupillometer has an internal fixation target, often a small light or dot, for the patient to look at. This ensures the patient's eyes are in the primary position, allowing for an accurate measurement of the distance from the center of the bridge of the nose to the center of each pupil for a precise monocular PD.

Question 3

While verifying a prescription with a manual lensometer, the optician finds that the sphere lines come into focus at -1.50 D. After turning the power drum further, the cylinder lines come into focus at -3.00 D. To correctly identify the axis of the cylinder, what must be done?

Accepted Answer

Adjust the axis wheel until the three parallel cylinder lines appear straight and unbroken.

Answer

In manual lensometry for a spherocylindrical lens, after focusing the sphere lines, the next step is to focus the cylinder lines. If the cylinder lines (the triple lines) appear broken or skewed, the axis wheel must be rotated until they are continuous and straight. The reading on the axis wheel at this point indicates the correct cylinder axis.

Question 4

A patient is being evaluated for a soft contact lens fitting. Which slit lamp illumination technique is most effective for assessing the overall fit, including lens movement and centration, without causing excessive tearing?

Accepted Answer

Diffuse illumination with low to medium magnification

Answer

Diffuse illumination provides a broad, even light that allows for a general overview of the anterior eye and the contact lens. Using low to medium magnification (6x to 16x) is ideal for observing the lens's position, coverage, and movement upon blinking, providing a comprehensive assessment of the fit without the intensity of other techniques that might cause reflex tearing and alter the natural fit.

Question 5

Which of the following is the first and most critical step an optician must perform before using a manual lensometer to ensure accurate readings for any patient's glasses?

Accepted Answer

Focusing the eyepiece for their own eye.

Answer

Before any measurements are taken, the eyepiece of the lensometer must be focused for the individual operator's eye. This is done by turning the eyepiece to the most plus setting, then slowly turning it back until the reticle (crosshairs) is in sharp focus. Failure to do so will introduce error into all subsequent power readings.

NOCE - National Opticianry Competency Examination Practice Test

NOCE - National Opticianry Competency Examination Practice Test

NOCE Optical Instrumentation Usage Questions and Answers