NEC Wiring and Protection Questions and Answers

Question 1

An individual branch circuit supplies a continuous-duty motor with a full-load current (FLA) of 30A. The circuit conductors are sized appropriately. According to NEC Article 430, what is the maximum standard size inverse-time circuit breaker that can be used for short-circuit and ground-fault protection for this motor?

Accepted Answer

75A

Answer

NEC Table 430.52 allows the rating of an inverse-time circuit breaker used for motor branch-circuit, short-circuit, and ground-fault protection to be a maximum of 250% of the motor's full-load current (FLA). For a 30A motor, the calculation is 30A x 2.50 = 75A. Since 75A is a standard size overcurrent device listed in NEC 240.6(A), it is the maximum permitted size.

Question 2

When installing conductors in parallel, which of the following conditions is NOT required by NEC 310.10(G)?

Accepted Answer

The conductors must be the same color.

Answer

NEC 310.10(G) requires that paralleled conductors be the same length, consist of the same conductor material, have the same circular mil area, and have the same insulation type. While color-coding is essential for identifying phases and grounded conductors, the NEC does not mandate that each parallel set for a specific phase must be the same color as the other sets for that same phase.

Question 3

A 400A feeder is installed using two parallel runs of 3/0 AWG THHN copper conductors per phase in separate nonmetallic conduits. Based on the rating of the feeder's 400A overcurrent protective device, what is the minimum size required for the wire-type equipment grounding conductor (EGC) in each conduit according to NEC Table 250.122?

Accepted Answer

3 AWG Copper

Answer

According to NEC 250.122(F), when conductors are installed in parallel in multiple raceways, a full-sized equipment grounding conductor, based on the rating of the overcurrent device, must be installed in each raceway. Looking at Table 250.122, for a 400A overcurrent device, the minimum size for a copper equipment grounding conductor is 3 AWG.

Question 4

What is the primary purpose of bonding the metallic, non-current-carrying parts of an electrical system, such as enclosures and raceways?

Accepted Answer

To establish a low-impedance path for fault current to facilitate the operation of overcurrent devices.

Answer

Per NEC Article 250, bonding creates an effective ground-fault current path. This path must be a low-impedance circuit that can safely carry the maximum fault current, allowing the circuit breaker or fuse to operate quickly and clear the fault. While grounding connects the system to the earth to stabilize voltage and protect from lightning, bonding specifically connects conductive parts to each other and to the system grounding conductor.

Question 5

Unless specifically permitted otherwise, what is the maximum overcurrent protection allowed for a 12 AWG copper conductor according to NEC 240.4(D)?

Accepted Answer

20A

Answer

NEC 240.4(D) provides specific overcurrent protection limitations for small conductors. For 12 AWG copper conductors, the maximum standard overcurrent protective device rating is 20 amperes, regardless of the conductor's higher ampacity rating listed in Table 310.16.

NEC Practice Test

NEC Practice Test

NEC Wiring and Protection Questions and Answers