HUD HUD Manufactured Housing Standards 2

Question 1

What organization is responsible for monitoring HUD-approved manufactured home installation in most states?

Accepted Answer

State Administrative Agency (SAA)

Answer

State Administrative Agencies (SAAs) administer and enforce HUD manufactured housing standards at the state level under a cooperative agreement with HUD.

Question 2

A manufactured home's serial number can typically be found in which location?

Accepted Answer

On the tongue of the chassis near the hitch

Answer

The Vehicle Identification Number (VIN) or serial number is stamped on the chassis tongue near the hitch and is also on the Data Plate.

Question 3

Which HUD standard governs the thermal insulation requirements for manufactured homes?

Accepted Answer

24 CFR Part 3280.505

Answer

24 CFR Part 3280.505 establishes thermal protection requirements including insulation R-values for walls, roofs, and floors based on thermal zone.

Question 4

When inspecting a HUD-code manufactured home, what does the absence of a HUD Certification Label most likely indicate?

Accepted Answer

The home was built before 1976

Answer

Homes built before June 15, 1976 predate HUD standards and would not have a certification label; post-1976 homes without a label may be non-compliant.

Question 5

Under HUD standards, what minimum thickness of foam plastic insulation requires a thermal barrier such as gypsum board when used inside a manufactured home?

Accepted Answer

Any exposed foam plastic insulation regardless of thickness

Answer

HUD standards require that any exposed foam plastic insulation inside a manufactured home be protected by a thermal barrier due to fire spread concerns.

(HUD) Certified Housing and Urban Development Inspector Practice Test

(HUD) Certified Housing and Urban Development Inspector Practice Test

HUD HUD Manufactured Housing Standards 2