GROL - General Radiotelephone Operator License Amplifier and Oscillator Circuits Questions and Answers

Question 1

For an LC oscillator to begin and sustain oscillation, which condition must be met according to the Barkhausen criterion?

Accepted Answer

The total phase shift around the feedback loop must be 0° or 360°, and the loop gain must be slightly greater than 1.

Answer

The Barkhausen criterion states two conditions for sustained oscillation: 1) The total phase shift around the amplifier and feedback loop must be 0° or an integer multiple of 360°. 2) The magnitude of the loop gain (|Aβ|) must be equal to or greater than 1. In practice, the gain must be slightly greater than 1 to initiate the oscillation, which then stabilizes at 1 as the amplitude builds.

Question 2

A technician is designing an RF power amplifier for a continuous wave (CW) transmitter. To achieve the highest possible efficiency, which class of amplifier should be selected?

Accepted Answer

Class C

Answer

Class C amplifiers offer the highest theoretical efficiency (approaching 90%) because the active device (transistor) conducts for less than 180° of the input signal cycle. While this creates high distortion, the use of a tuned LC tank circuit at the output filters out harmonics, making it ideal for high-efficiency RF applications like CW transmitters where linearity is not the primary concern.

Question 3

What is the primary distinguishing feature between a Hartley oscillator and a Colpitts oscillator?

Accepted Answer

A Hartley oscillator uses a tapped inductor for feedback, while a Colpitts oscillator uses a tapped capacitive divider.

Answer

The fundamental difference lies in how the feedback signal is developed in the LC tank circuit. A Hartley oscillator uses an inductive voltage divider (a single tapped inductor or two separate inductors) to provide feedback. A Colpitts oscillator, conversely, uses a capacitive voltage divider (two capacitors in series) to provide the necessary feedback.

Question 4

In an Armstrong oscillator circuit, how is the essential positive feedback provided to sustain oscillations?

Accepted Answer

Through magnetic coupling between a "tickler" coil in the output circuit and the tank coil in the input circuit.

Answer

The Armstrong oscillator, also known as a tickler oscillator, achieves feedback through mutual inductance. A transformer magnetically couples energy from the output (collector or drain) circuit back to the input (base or gate) LC tank circuit. The phasing of the transformer windings is critical to ensure the feedback is positive (regenerative).

Question 5

A technician observes that the output of a newly constructed oscillator has significant harmonic distortion and is not a pure sine wave. Which of the following is the most likely cause?

Accepted Answer

The loop gain of the oscillator is significantly greater than 1.

Answer

For a pure sine wave, the Barkhausen criterion requires the loop gain to be exactly unity. In practice, the gain is made slightly greater than 1 to start the oscillation. If the loop gain is excessively high, the amplitude of the oscillations will build until the amplifier begins to clip or operate in a non-linear region, which introduces harmonics and distorts the sinusoidal output.

(GROL) General Radiotelephone Operator License Practice Test

(GROL) General Radiotelephone Operator License Practice Test

GROL - General Radiotelephone Operator License Amplifier and Oscillator Circuits Questions and Answers