F80 Inspection Procedures 5

Question 1

Which of the following is the correct sequence for a brake performance test on a dynamometer?

Accepted Answer

Place vehicle on rollers, apply brakes at a specified speed, and measure brake force on each wheel

Answer

A brake dynamometer test places driven wheels on rollers, applies brakes at a set speed, and measures individual wheel brake force.

Question 2

During inspection, an inspector finds the vehicle's odometer has been tampered with. What is the required action?

Accepted Answer

Reject the vehicle and report the tampering to the appropriate authority

Answer

Odometer tampering is a federal offense; the inspector must reject the vehicle and report the violation to the appropriate state or federal authority.

Question 3

What condition of a vehicle's battery or electrical cables would cause an inspector to reject a vehicle?

Accepted Answer

Cracked or severely corroded cables with exposed conductors near fuel lines

Answer

Severely damaged cables with exposed conductors near fuel lines create a fire and electrical hazard warranting rejection.

Question 4

Which lighting component, if inoperative, would NOT typically result in an automatic rejection in most states?

Accepted Answer

One of two rear license plate lights on a vehicle equipped with two

Answer

Many states allow a single inoperative license plate light if the other illuminates the plate adequately, while headlights, brake lights, and turn signals are mandatory.

Question 5

A vehicle undergoes an OBD-II emissions test and returns two ready monitors set to 'not ready.' What happens?

Accepted Answer

The vehicle fails the OBD portion — most states allow a maximum of one incomplete monitor

Answer

Most US states allow a maximum of one incomplete OBD-II monitor (two for older vehicles); two incomplete monitors is a failure.

F80 Practice Test

F80 Practice Test

F80 Inspection Procedures 5