F80 Inspection Procedures 3

Question 1

During a vehicle inspection, which brake component must be checked for minimum thickness?

Accepted Answer

Brake rotor or drum

Answer

Brake rotors and drums must meet minimum thickness specifications to ensure adequate heat dissipation and stopping power.

Question 2

What is the correct procedure when inspecting a vehicle's steering for excessive play?

Accepted Answer

Measure free movement before the front wheels begin to move

Answer

Steering free play is measured as the amount the wheel turns before the front tires begin to respond.

Question 3

During an inspection, a tire is found to have a tread depth of 1.5/32 inch. What is the correct action?

Accepted Answer

Fail the vehicle — tread is below the 2/32 inch minimum

Answer

Federal and most state standards require a minimum tread depth of 2/32 inch; 1.5/32 inch fails inspection.

Question 4

An inspector notices that a vehicle's horn does not sound when activated. This finding results in a:

Accepted Answer

Rejection — the horn is a required safety device

Answer

A functioning horn is a required safety device; a non-functioning horn is grounds for rejection.

Question 5

When inspecting seat belts, which condition would cause a vehicle to fail?

Accepted Answer

A belt with frayed webbing or a damaged buckle latch

Answer

Frayed webbing or a damaged buckle latch compromises restraint effectiveness and is grounds for rejection.

F80 Practice Test