CWS Basic RF Principles Questions and Answers

Question 1

An RF signal travels between a transmitter and receiver. As it propagates through the air, it encounters a large, smooth metal-paneled building. Which of the following RF behaviors is MOST likely to occur?

Accepted Answer

Reflection

Answer

Reflection occurs when an RF wave strikes a smooth surface that is large relative to the wavelength of the signal. A metal-paneled building is a prime example of such a surface, causing the signal to bounce off.

Question 2

A network technician is setting up a point-to-point wireless bridge between two buildings. To ensure a reliable link, they must account for the area around the visual line of sight that needs to be clear of obstructions. What is this area called?

Accepted Answer

The Fresnel Zone

Answer

The Fresnel Zone is an elliptical area immediately surrounding the visual path of an RF link. For optimal performance, especially in point-to-point links, it's recommended that at least 60% of the first Fresnel Zone be clear of obstructions to avoid signal degradation.

Question 3

Which of the following units of measurement represents an absolute power level referenced to 1 milliwatt?

Accepted Answer

dBm

Answer

dBm stands for 'decibels relative to 1 milliwatt'. It is an absolute unit of power, where 0 dBm is equal to 1 mW. dBi and dBd are relative gain values compared to isotropic or dipole antennas respectively, and dB is a relative ratio between two values.

Question 4

A wireless engineer notices that as the frequency of an RF signal increases, its wavelength __________.

Accepted Answer

decreases

Answer

Frequency and wavelength are inversely proportional. As the frequency (the number of cycles per second) of an RF signal increases, the physical distance of each wave (the wavelength) becomes shorter.

Question 5

What does a Voltage Standing Wave Ratio (VSWR) of 1:1 on an antenna system signify?

Accepted Answer

A perfect impedance match between the transmitter, cable, and antenna.

Answer

A VSWR of 1:1 indicates a perfect impedance match, meaning all the power from the transmitter is being radiated by the antenna with no power being reflected back. This is the ideal, though often unachievable, state for maximum power transfer efficiency.

CWS Exam Practice Test

CWS Exam Practice Test

CWS Basic RF Principles Questions and Answers