CTS AV Design Documentation and Drawings

Question 1

What type of AV drawing shows the interconnections between all equipment in a system, including signal types, connector types, and cable designations?

Accepted Answer

Signal flow diagram (also called a system schematic or interconnect diagram)

Answer

A signal flow diagram (or interconnect diagram / system schematic) illustrates every piece of equipment and every cable connection in a system, labeled with signal types (HDMI, analog audio, RS-232, etc.) and connector types. It is the primary reference for installation, troubleshooting, and future modifications. Floor plans show room layout; rack elevations show physical rack arrangement.

Question 2

In AV documentation, what is a 'Bill of Materials' (BOM)?

Accepted Answer

A comprehensive list of all equipment, cable, connectors, and hardware required for a project with quantities and part numbers

Answer

A Bill of Materials is the itemized inventory of everything needed to build the system—each piece of equipment with its manufacturer part number, quantity, description, and often pricing. It is generated from the system design and drives purchasing. It is distinct from the as-built drawings (which show what was installed) and the user manual (which explains operation).

Question 3

A reflected ceiling plan (RCP) is used in AV design primarily to show:

Accepted Answer

The locations of ceiling-mounted loudspeakers, projectors, microphones, and lighting fixtures

Answer

A reflected ceiling plan shows the ceiling as if it were reflected down onto the floor plan, revealing the positions of all ceiling-mounted elements: speakers, projectors, microphones, screens, HVAC diffusers, lighting, and structural elements. AV designers use RCPs to coordinate device placement and avoid conflicts with other trades.

Question 4

What is the purpose of 'as-built drawings' delivered at the end of an AV installation project?

Accepted Answer

To document the system as it was actually installed, reflecting any field modifications made during construction

Answer

As-built drawings (also called record drawings) capture the system exactly as it was installed—including any deviations from the original design that were made in the field. They are essential for future maintenance, upgrades, or troubleshooting because they reflect reality, not the original plan. Discrepancies between design drawings and as-builts are common due to field conditions.

Question 5

Which symbol on a standard AV signal flow diagram typically represents an audio amplifier?

Accepted Answer

A triangle pointing in the direction of signal flow

Answer

In standard electronics and AV schematic notation, an amplifier is represented by a triangle with the point facing the direction of signal flow (output direction). This convention comes from IEEE and IEC schematic standards and is universally recognized in AV system documentation. The triangle visually suggests gain—a small signal enters the wide base and a larger signal exits the point.

(CTS) Certified Technology Specialist Practice Test

(CTS) Certified Technology Specialist Practice Test

CTS AV Design Documentation and Drawings