CSWP Evaluation Structure 2

Question 1

When performing interference detection on an assembly, which result indicates a valid press-fit condition?

Accepted Answer

Interference is listed but marked as non-interfering

Answer

SolidWorks allows you to mark specific interferences as non-interfering to represent intended press-fit or shrink-fit conditions.

Question 2

In SolidWorks, which tool would you use to measure the minimum distance between two non-touching components in an assembly?

Accepted Answer

Measure tool

Answer

The Measure tool can report the minimum distance, maximum distance, and center-to-center distance between selected entities.

Question 3

What does the 'Treat coincident surfaces as interferences' option do in Interference Detection?

Accepted Answer

Flags shared faces between adjacent parts as interference

Answer

Enabling this option causes SolidWorks to report coincident (touching) surfaces as interferences, useful for identifying improper contact conditions.

Question 4

Which Mass Properties value would change if you alter the material density of a part in an assembly without changing its geometry?

Accepted Answer

Mass

Answer

Mass = Density × Volume; changing density directly changes mass while volume and surface area remain geometry-dependent.

Question 5

When evaluating a CSWP part model, the moment of inertia is reported relative to which default coordinate system?

Accepted Answer

The output coordinate system

Answer

SolidWorks reports moments of inertia relative to the output coordinate system, which defaults to the part origin unless overridden.

(CSWP) Certified Solidworks Professional Practice Test