CHST - Construction Health and Safety Technician Fall Protection and Prevention Questions and Answers 1

Question 1

According to OSHA 29 CFR 1926 Subpart M, what is the minimum height at which fall protection is required for construction workers on a walking/working surface with an unprotected side or edge?

Accepted Answer

6 feet

Answer

4 feet

Answer

5 feet

Answer

10 feet

Question 2

A construction worker is tasked with installing a safety net system. Which of the following installation requirements is NOT compliant with OSHA standards?

Accepted Answer

The net is drop-tested with a 200-pound bag of sand before use.

Answer

The net is installed no more than 30 feet below the working surface.

Answer

The mesh openings of the net do not exceed 6 inches by 6 inches.

Answer

The border rope of the net has a minimum breaking strength of 5,000 pounds.

Question 3

A personal fall arrest system (PFAS) consists of three primary components. Which of the following is essential for a complete PFAS?

Accepted Answer

Full-body harness, connecting device, and anchor point

Answer

Body belt, lanyard, and anchor point

Answer

Full-body harness, guardrail, and anchor point

Answer

Safety net, body harness, and lanyard

Question 4

When setting up a standard guardrail system on a construction site, what is the required top rail height above the walking/working surface according to OSHA?

Accepted Answer

42 inches +/- 3 inches

Answer

36 inches +/- 3 inches

Answer

48 inches +/- 3 inches

Answer

30 inches +/- 3 inches

Question 5

An employer has several workers who will be exposed to fall hazards on a new construction project. According to OSHA 1926.503, when must the employer provide fall protection training?

Accepted Answer

Before any employee is exposed to a fall hazard.

Answer

Within the first week of exposure to the fall hazard.

Answer

Only after a near-miss or incident occurs.

Answer

When an employee's performance shows a lack of understanding.

Question 6

A supervisor is inspecting a standard guardrail system and notices several issues. Which of the following conditions would be considered an OSHA violation?

Accepted Answer

Intermediate vertical members (balusters) are spaced 20 inches apart.

Answer

The top rail can withstand a force of 200 pounds.

Answer

The midrail is located halfway between the top rail and the floor.

Answer

Wire rope used for the top rail is flagged every 6 feet.