Air Conditioning Repair Preventive Maintenance and System Efficiency Flashcards
6 cards from real Air Conditioning Repair practice questions. Tap to flip, then mark Knew It or Still Learning — missed cards come back until you master them.
Read the first 6 Air Conditioning Repair Preventive Maintenance and System Efficiency flashcards as text
What is the correct procedure for testing a dual-run capacitor on a residential AC unit?
Answer: Discharge it, then test capacitance with a capacitor-rated multimeter
A dual-run capacitor must be safely discharged before testing its capacitance with a meter rated for capacitor testing.
Which measurement indicates proper lubrication is needed on older belt-drive blower motors?
Answer: Motor running hot above its rated temperature or unusual squealing noise
Excessive heat or squealing from a belt-drive motor bearing signals inadequate lubrication and potential bearing failure.
A technician measures the outdoor ambient temperature at 95°F. What is the expected normal operating range for high-side (discharge) pressure on an R-410A system?
Answer: 380–420 PSIG
For R-410A at 95°F ambient, normal high-side (condensing) pressure is typically in the 380–420 PSIG range.
What is the purpose of a condensate trap installed on an AC air handler?
Answer: To prevent negative duct pressure from pulling sewer gases back through the drain line
A condensate trap creates a water seal that prevents negative static pressure in the air handler from breaking the drain flow and introducing odors or pathogens.
During a maintenance check, the technician notices the outdoor fan motor is drawing more amps than its nameplate rating. What is the most likely cause?
Answer: Failing motor bearings or a failing capacitor
A motor drawing above nameplate amperage usually indicates worn bearings creating drag or a weak start/run capacitor failing to support the motor.
What is the correct method for disposing of old compressor oil removed during system maintenance?
Answer: Dispose of it as hazardous waste through an approved recycling or disposal facility
Compressor oil from refrigeration systems is considered hazardous waste and must be disposed of through a licensed recycling or hazardous waste facility.
Written and edited by Nathan Beja, founder of Practice Test Geeks, with AI assistance. We have not yet matched this exam's facts to an official source, so confirm fees, dates and rules with the exam body. Editorial policy