← All Agricultural/Bioengineering Flashcard Decks

Strength of Materials Flashcards

7 cards from real Agricultural/Bioengineering practice questions. Tap to flip, then mark Knew It or Still Learning — missed cards come back until you master them.

Read the first 7 Strength of Materials flashcards as text
  1. A steel grain bin support column has a cross-sectional area of 0.005 m² and carries an axial compressive load of 50 kN. What is the compressive stress?

    Answer: 10 MPa

    Stress = Force / Area = 50,000 N / 0.005 m² = 10 MPa.

  2. Which of the following materials has the highest modulus of elasticity (stiffness) and is commonly used in agricultural machinery frames?

    Answer: Structural steel

    Structural steel has a modulus of elasticity of approximately 200 GPa, far higher than the other options.

  3. A wooden irrigation flume beam spans 4 m and carries a uniformly distributed load. If the maximum bending moment is 8 kN·m and the section modulus is 0.002 m³, what is the bending stress?

    Answer: 4 MPa

    Bending stress = M / S = 8,000 N·m / 0.002 m³ = 4 MPa.

  4. In a thin-walled cylindrical silo storing grain, which stress is approximately twice the longitudinal (axial) stress when internal pressure acts?

    Answer: Hoop (circumferential) stress

    For a thin-walled pressure vessel, hoop stress = pd/2t is twice the longitudinal stress = pd/4t.

  5. A tractor drawbar pin experiences a shear force of 20 kN across two shear planes (double shear). If the pin diameter is 20 mm, what is the average shear stress?

    Answer: 15.9 MPa

    Double shear area = 2 × π(0.01)² = 6.283×10⁻⁴ m²; τ = 20,000 / 6.283×10⁻⁴ ≈ 31.8 MPa — wait, single shear area = π(0.01)² = 3.14×10⁻⁴ m², double shear τ = 20,000 / (2 × 3.14×10⁻⁴) ≈ 31.8 MPa.

  6. What does the 'neutral axis' of a beam cross-section represent during bending?

    Answer: The axis where bending stress is zero

    The neutral axis is the line within a beam's cross-section where bending stress transitions from tension to compression and equals zero.

  7. A cast iron pump housing in an irrigation system is subjected to a tensile stress of 80 MPa. If the ultimate tensile strength of the cast iron is 200 MPa, what is the factor of safety?

    Answer: 2.5

    Factor of safety = Ultimate strength / Applied stress = 200 / 80 = 2.5.

How this page was made: written with AI tools and published by Nathan Beja, founder of Practice Test Geeks, who is responsible for its content. Exam facts are checked against the official sources listed below. Not reviewed by a subject-matter expert. Editorial policy

Sources & references

Exam facts on this page (fees, format, dates, passing scores) are checked against these official sources; the date is our last check. Editorial policy

  1. ncees.org — Eligibility, exam format, registration, score release, fees, retake policy, exam information · verified Nov 2026
  2. pearsonvue.com — Test delivery · verified Oct 2026