TN LLE Commercial Load Calculations 3

Question 1

Per NEC 220.14(H), what VA per linear foot is used for multioutlet assemblies where simultaneous use is likely in a commercial setting?

Accepted Answer

180 VA per foot

Answer

When simultaneous use of multioutlet assemblies is likely, NEC 220.14(H)(2) requires 180 VA per foot of the assembly.

Question 2

When calculating sign lighting load for a commercial building per NEC 220.14(F), what is the minimum VA for each commercial occupancy?

Accepted Answer

1,200 VA

Answer

NEC 220.14(F) requires a minimum of 1,200 VA for sign or outline lighting for each commercial occupancy with ground-floor frontage.

Question 3

For a commercial building with 30 kW of general lighting load, what demand factor reduction is permitted per NEC Table 220.42?

Accepted Answer

100% of first 12,500 VA plus 50% of remainder

Answer

Per NEC Table 220.42, commercial occupancies use 100% of the first 12,500 VA and 50% of the remainder for general lighting demand calculations.

Question 4

What is the standard method for calculating the neutral load on a 3-phase, 4-wire commercial service?

Accepted Answer

Maximum unbalanced load between any phase and neutral

Answer

The neutral conductor must be sized for the maximum unbalanced load — the greatest load between any single phase and neutral.

Question 5

Per NEC 220.44, what demand factor can be applied to receptacle loads exceeding 10 kVA in a commercial building?

Accepted Answer

100% of first 10 kVA plus 50% of remainder

Answer

NEC 220.44 permits a demand factor of 100% for the first 10 kVA of receptacle load and 50% for the amount exceeding 10 kVA in non-dwelling occupancies.

TN LLE - Tennessee Limited Licensed Electrician Practice Test

TN LLE - Tennessee Limited Licensed Electrician Practice Test

TN LLE Commercial Load Calculations 3