Practice Test Geeks(Steamfitter) Steamfitter Pipefitter Exam Practice Test
← All STEAMFITTER Flashcard Decks

Safety Regulations and Compliance Flashcards

7 cards from real STEAMFITTER practice questions. Tap to flip, then mark Knew It or Still Learning — missed cards come back until you master them.

Read the first 7 Safety Regulations and Compliance flashcards as text

  1. Under OSHA 29 CFR 1910.147, what is the minimum energy control procedure requirement before servicing pressurized piping systems?

    Answer: Lockout/tagout all energy sources

    OSHA's Control of Hazardous Energy standard (29 CFR 1910.147) requires lockout/tagout of all energy sources before servicing pressurized systems.

  2. Which ASME standard governs the fabrication and inspection of boilers and pressure vessels used in steamfitting work?

    Answer: ASME BPVC Section I

    The ASME Boiler and Pressure Vessel Code (BPVC) Section I covers power boilers and is the primary fabrication standard for steam pressure vessels.

  3. A steamfitter notices a steam trap continuously blowing live steam to atmosphere. What is the immediate safety concern?

    Answer: Scalding hazard and energy waste

    Live steam discharged to atmosphere creates an immediate scalding hazard to workers and also represents significant energy waste.

  4. Per OSHA 1910.132, what must an employer do before selecting PPE for workers exposed to steam hazards?

    Answer: Conduct a workplace hazard assessment

    OSHA 1910.132 requires employers to perform a hazard assessment of the workplace to determine what PPE is necessary before selection.

  5. What does the term 'MAWP' stand for, and why is it critical for steamfitter safety compliance?

    Answer: Maximum Allowable Working Pressure — it sets the safe operating limit

    MAWP (Maximum Allowable Working Pressure) defines the highest pressure at which a vessel or system may be safely operated per code.

  6. Which regulation requires steamfitters working in confined spaces to have an attendant stationed outside the space?

    Answer: OSHA 29 CFR 1910.146

    OSHA 29 CFR 1910.146 (Permit-Required Confined Spaces) mandates that an attendant remain outside to monitor entrants and initiate rescue if needed.

  7. When performing a hydrostatic pressure test on a new steam piping system, to what multiple of the design pressure is the test typically conducted per ASME B31.1?

    Answer: 1.5 times design pressure

    ASME B31.1 requires hydrostatic leak tests at a minimum of 1.5 times the system design pressure to verify integrity without overstressing components.