SPRAT Safety and Compliance 5

Question 1

Which statement best describes SPRAT's two-rope system requirement?

Accepted Answer

Each technician uses a working line and an independent safety (backup) line

Answer

A separately anchored backup line protects the technician if the main working line or its anchors fail.

Question 2

Who should do the documented periodic inspections of rope access equipment?

Accepted Answer

A competent person, following the manufacturer's instructions

Answer

Besides each user's check before use, a competent person must carry out and record periodic inspections.

Question 3

A Level I technician is asked to rig anchors without supervision on a new job. What does SPRAT guidance say?

Accepted Answer

Level I technicians should work under the supervision of a Level III

Answer

Level I technicians work under the direct supervision of a Level III, who is responsible for the rigging and safety of the job.

Question 4

What hazard makes hot work such as welding or grinding especially dangerous for rope access?

Accepted Answer

Heat and sparks can melt or damage synthetic ropes

Answer

Synthetic ropes melt at relatively low temperatures, so hot work needs rope protection, fire watches, or alternative suspension.

Question 5

What is the best way to keep reliable communication between technicians on rope and the ground team?

Accepted Answer

Set up and test a communication method such as radios or signals before work starts

Answer

A communication method that has been agreed on and tested is needed for routine coordination and for emergencies.

SPRAT - Society of Professional Rope Access Technicians Certification Practice Test