RSP Signal Person Responsibilities & Communication 3

Question 1

What does the ASME/ANSI standard hand signal for 'move slowly' require the signal person to do?

Accepted Answer

Place one hand motionless above the moving hand signal

Answer

The 'move slowly' signal is given by placing a stationary hand above the hand giving the directional motion signal.

Question 2

Which signal indicates 'hoist'?

Accepted Answer

With forearm vertical, forefinger pointing up, move hand in small horizontal circles

Answer

The standard 'hoist' signal is a vertical forearm with the index finger pointing up while moving the hand in small horizontal circles.

Question 3

A signal person is stationed where they cannot maintain visual contact with both the operator and the load simultaneously. What is the correct procedure?

Accepted Answer

Use a relay person or radio communication to bridge the gap

Answer

When a single signal person cannot see both the operator and the load, a relay person or radio communication system must be used.

Question 4

What is the standard hand signal for 'lower'?

Accepted Answer

With arm extended downward, forefinger pointing down, move hand in small horizontal circles

Answer

The 'lower' signal mirrors the 'hoist' signal but with the arm pointing down, moving in small horizontal circles.

Question 5

When using radio communication during crane operations, what must a signal person do before giving a movement command?

Accepted Answer

Identify themselves and confirm the operator can hear clearly

Answer

Before giving radio movement commands, the signal person must identify themselves and confirm clear communication with the operator.

(RSP) Rigger and Signal Person Certification Practice Test

(RSP) Rigger and Signal Person Certification Practice Test

RSP Signal Person Responsibilities & Communication 3