RSP OSHA Regulations & Standards 3

Question 1

OSHA 29 CFR 1926.1417 requires crane operators to perform a pre-shift inspection. Which of the following is included in this inspection?

Accepted Answer

Inspecting control mechanisms for maladjustment

Answer

The pre-shift inspection under 29 CFR 1926.1417 includes checking control mechanisms for maladjustment, deterioration, or damage.

Question 2

Under OSHA Subpart CC, when must a competent person inspect rigging prior to each shift?

Accepted Answer

Prior to each shift in which the rigging will be used

Answer

OSHA requires a competent person to inspect rigging prior to each shift in which that rigging equipment will be used.

Question 3

Which OSHA provision requires that employees must not be positioned under a suspended load?

Accepted Answer

29 CFR 1926.1425

Answer

29 CFR 1926.1425 prohibits positioning employees under suspended loads except in specific limited circumstances with protective measures.

Question 4

According to OSHA 29 CFR 1926.1408, what is the minimum clearance distance from energized overhead power lines up to 50 kV when operating a crane?

Accepted Answer

10 feet

Answer

OSHA 29 CFR 1926.1408 requires a minimum 10-foot clearance from energized overhead lines up to 50 kV.

Question 5

Under OSHA Subpart CC, what documentation must be available at the jobsite for a crane being used in construction?

Accepted Answer

Load charts, equipment manual, and applicable inspection records

Answer

OSHA requires that load charts, the equipment manual, and applicable inspection records be available at the jobsite for the crane in use.

(RSP) Rigger and Signal Person Certification Practice Test