Subfloor Preparation & Assessment Flashcards
7 cards from real RRT practice questions. Tap to flip, then mark Knew It or Still Learning — missed cards come back until you master them.
Read the first 7 Subfloor Preparation & Assessment flashcards as text
What is the maximum allowable moisture vapor emission rate (MVER) for a concrete subfloor before installing carpet with standard adhesive?
Answer: 5 lbs per 1,000 sq ft per 24 hours
Industry standards (ASTM F1869) generally set 5 lbs/1,000 sq ft/24 hours as the maximum MVER for adhesive carpet installations on concrete.
When assessing a wood subfloor for carpet reinstallation, what is the maximum acceptable deflection under a concentrated 200-lb load?
Answer: L/360
L/360 is the standard deflection limit for subfloors receiving hard or resilient flooring; carpet installations follow the same structural guideline.
Which test method uses a calcium chloride dish sealed to a concrete slab to measure moisture emissions?
Answer: ASTM F1869
ASTM F1869 is the Standard Test Method for Measuring Moisture Vapor Emission Rate of Concrete Subfloor Using Anhydrous Calcium Chloride.
A concrete subfloor has a pH reading of 10. What does this indicate for carpet installation?
Answer: The slab is highly alkaline and may affect adhesive bond
A pH above 9 indicates high alkalinity, which can break down adhesives and adhesive bonds, requiring mitigation before installation.
What is the recommended flatness tolerance for a concrete subfloor prior to carpet installation?
Answer: 3/16 inch in 10 feet
CRI (Carpet and Rug Institute) and most manufacturers specify no more than 3/16 inch variation in 10 feet for subfloor flatness.
Which of the following is the correct procedure when a wood subfloor has protruding nail heads before carpet installation?
Answer: Set the nail heads below the surface with a nail set
Protruding nail heads must be set below the surface so they do not telegraph through the carpet or damage it over time.
When evaluating a subfloor that shows cupping in wood planks, what is the primary cause of this condition?
Answer: Moisture imbalance between the top and bottom face of the plank
Cupping occurs when the bottom face of a wood plank absorbs more moisture than the top face, causing the edges to rise above the center.
Written and edited by Nathan Beja, founder of Practice Test Geeks, with AI assistance. Exam facts are checked against the official sources linked below. Editorial policy
Sources & references
Exam facts on this page (fees, format, dates, passing scores) are checked against these official sources; the date is our last check. Editorial policy
- iicrc.org — Test delivery, eligibility, fees, renewal, score release, test dates, retake fee, retake policy, passing score · verified Nov 2026