Pipeline Installation Flashcards
7 cards from real RMGA practice questions. Tap to flip, then mark Knew It or Still Learning — missed cards come back until you master them.
Read the first 7 Pipeline Installation flashcards as text
What is the purpose of the 'blow-down' procedure performed on medical gas pipelines after installation?
Answer: To purge construction debris, flux residue, and moisture from the interior
The blow-down procedure uses high-velocity nitrogen to remove particulates, flux residue, and moisture that could contaminate medical gases or harm patients.
In a medical gas pipeline system, what is a 'riser'?
Answer: A vertical section of piping connecting different floor levels
A riser is a vertical run of piping that carries medical gas between floors of a multi-story healthcare facility.
Which of the following conditions requires a pipeline installer to stop work and notify the RMGA immediately?
Answer: Discovery of an unlabeled pipeline of unknown content
An unlabeled pipeline of unknown content represents a potential cross-connection or contamination hazard that must be investigated before work continues.
Medical vacuum systems serving patient care areas must maintain a minimum vacuum level of:
Answer: -19 in Hg
NFPA 99 requires medical vacuum systems in patient care areas to maintain at least -19 in Hg (inches of mercury) at the point of use.
When a medical gas pipeline must cross another utility line, which arrangement is preferred?
Answer: The medical gas pipe should pass above the other utility
Medical gas piping should pass above other utilities to reduce contamination risk from leaks in water or drain piping and to maintain easier access for inspection.
Which documentation must be provided to the owner upon completion of a medical gas pipeline installation per NFPA 99?
Answer: As-built drawings, test reports, certifications, and training records
NFPA 99 requires a complete documentation package including as-built drawings, all test results, installer/verifier certifications, and training records at project closeout.
What is the maximum operating pressure for a standard medical oxygen distribution pipeline system?
Answer: 50–55 psi
Standard medical oxygen (and most medical gas) distribution systems operate at 50–55 psi at the point of use per NFPA 99 design requirements.
How this page was made: written with AI tools and published by Nathan Beja, founder of Practice Test Geeks, who is responsible for its content. We have not yet matched this exam's facts to an official source, so confirm fees, dates and rules with the exam body. Not reviewed by a subject-matter expert. Editorial policy