SMAW (Shielded Metal Arc Welding) Flashcards
6 cards from real 456A practice questions. Tap to flip, then mark Knew It or Still Learning — missed cards come back until you master them.
Read the first 6 SMAW (Shielded Metal Arc Welding) flashcards as text
What does PWHT (Post Weld Heat Treatment) accomplish in SMAW welded joints?
Answer: Reduces residual stresses and tempers hard martensitic zones in the HAZ
PWHT (typically stress relief at 595–650°C for carbon steels) reduces residual welding stresses and tempers hard, brittle martensitic microstructures in the HAZ. It improves toughness, dimensional stability, and resistance to hydrogen-induced and stress-corrosion cracking. PWHT requirements are specified in codes such as ASME B31.3 and CSA W59.
What is the significance of the 'F-number' (F1–F6) assigned to filler metals in qualification records under CSA W47.1?
Answer: It groups filler metals with similar usability characteristics so that qualification with one covers others in the same group
F-numbers group electrodes and filler metals by their usability characteristics (not composition). Under CSA W47.1 and related codes, qualifying with a filler metal in one F-number group covers all filler metals within that group and, in some cases, lower-numbered groups, reducing the total number of qualification tests required.
A welder qualified in the 2G position (pipe horizontal, axis vertical) under CSA W47.1 is also qualified to weld in which positions?
Answer: 1G and 2G
Under CSA W47.1, a 2G qualification covers welding in the 1G and 2G positions. To weld in all positions, a 6G qualification is required. Position qualification rules follow a hierarchy where higher positions extend coverage to lower, less demanding positions.
What is the effect of excessive amperage on a SMAW weld bead profile?
Answer: Excessive convexity, undercut, burn-through, and increased spatter
Excessive amperage overheats the weld pool, causing a wide, flat or convex bead, undercut at the toes, burn-through on thin material, and increased spatter. It also enlarges the HAZ and can cause distortion.
What is the purpose of back gouging in a double-groove weld joint?
Answer: To remove the root pass from the back side, ensuring full penetration before depositing back-side weld metal
Back gouging removes the root pass and any defects (incomplete fusion, porosity, slag) from the back side of the joint before welding the back side. It ensures complete joint penetration and sound weld metal throughout the joint thickness. It can be done by arc gouging, grinding, or chipping.
Under CSA W59, what is the minimum preheat temperature for welding ASTM A36 carbon steel (25 mm thick) with E7018 electrodes?
Answer: 10°C (50°F)
CSA W59 specifies a minimum preheat of 10°C (50°F) for A36 carbon steel welded with low-hydrogen electrodes at thicknesses up to 38 mm. While A36 is a low-carbon steel, cold base metal below 10°C can cause rapid quenching and potential hydrogen cracking, so the minimum ambient/preheat temperature must be maintained.
How this page was made: written with AI tools and published by Nathan Beja, founder of Practice Test Geeks, who is responsible for its content. Exam facts are checked against the official sources listed below. Not reviewed by a subject-matter expert. Editorial policy
Sources & references
Exam facts on this page (fees, format, dates, passing scores) are checked against these official sources; the date is our last check. Editorial policy
- red-seal.ca — Exam format, exam information · verified Nov 2026
- skilledtradesontario.ca — Passing score, score release, time limit, renewal, score validity, eligibility, retake fee, test delivery, fees, retake policy · verified Nov 2026