← All 456A Flashcard Decks

SMAW (Shielded Metal Arc Welding) Flashcards

6 cards from real 456A practice questions. Tap to flip, then mark Knew It or Still Learning — missed cards come back until you master them.

Read the first 6 SMAW (Shielded Metal Arc Welding) flashcards as text
  1. What is the purpose of the 'crater fill' at the end of a SMAW weld bead?

    Answer: To prevent crater cracks by filling the depression left when the arc is extinguished

    When the arc is broken, a depression (crater) is left in the weld that can crack due to stress during solidification. Crater fill technique involves pausing at the end of the weld and allowing extra metal to fill the crater before breaking the arc. Crater cracks can propagate into the weld and are rejectable.

  2. What is the difference between 'open circuit voltage' (OCV) and 'arc voltage' in a SMAW welding machine?

    Answer: OCV is the voltage present when no arc is established; arc voltage is the lower voltage during active welding

    Open circuit voltage is the voltage at the output terminals of the welding machine when no current is flowing (no arc). Once the arc is struck, the voltage drops to the arc voltage (typically 20–35V for SMAW) while current increases to the set amperage. This is characteristic of constant-current (drooper) machines.

  3. Which type of welding power source characteristic is used for SMAW — constant current (CC) or constant voltage (CV)?

    Answer: Constant current (CC)

    SMAW uses a constant current (CC) power source, also called a 'drooper.' The output amperage remains relatively constant even if arc length changes, while voltage varies. This characteristic allows the welder to manually control arc length without causing large swings in current.

  4. What is the primary safety hazard associated with SMAW welding in a confined space according to Canadian OHS regulations?

    Answer: Oxygen deficiency or accumulation of toxic fumes without adequate ventilation

    In a confined space, SMAW produces fumes and gases (including CO, NOx, ozone, and metal fumes) that can displace oxygen or accumulate to toxic levels. Canadian OHS regulations (federal COHSR and provincial equivalents) require atmospheric testing, continuous ventilation, and standby rescue procedures for confined space welding.

  5. What is the minimum lens shade number recommended for SMAW welding at 150–200 amperes, per CSA Z94.3?

    Answer: Shade 10

    CSA Z94.3 (Eye and Face Protection) recommends a minimum shade 10 filter lens for SMAW welding at 150–200 amperes. Higher amperages require darker shades (up to shade 14) to protect against UV/IR radiation from the arc.

  6. What does 'interpass temperature' refer to and why is it controlled in multi-pass welds?

    Answer: The temperature of the weld between passes; controlled to prevent overheating, grain growth, and loss of toughness

    Interpass temperature is the temperature of the weld joint immediately before depositing the next weld pass. Maximum interpass temperature limits prevent excessive grain growth in the HAZ, loss of toughness, and potential cracking in hardenable steels. It is specified in the Welding Procedure Specification (WPS).

How this page was made: written with AI tools and published by Nathan Beja, founder of Practice Test Geeks, who is responsible for its content. Exam facts are checked against the official sources listed below. Not reviewed by a subject-matter expert. Editorial policy

Sources & references

Exam facts on this page (fees, format, dates, passing scores) are checked against these official sources; the date is our last check. Editorial policy

  1. red-seal.ca — Exam format, exam information · verified Nov 2026
  2. skilledtradesontario.ca — Passing score, score release, time limit, renewal, score validity, eligibility, retake fee, test delivery, fees, retake policy · verified Nov 2026