SMAW (Shielded Metal Arc Welding) Flashcards
6 cards from real 456A practice questions. Tap to flip, then mark Knew It or Still Learning — missed cards come back until you master them.
Read the first 6 SMAW (Shielded Metal Arc Welding) flashcards as text
What is the purpose of preheating before SMAW welding on high-carbon steel?
Answer: To reduce the cooling rate and prevent hydrogen-induced cracking
Preheating slows the cooling rate of the weld and heat-affected zone (HAZ), which reduces the risk of martensite formation and hydrogen-induced cracking. It also allows hydrogen time to diffuse out of the weld area before cracking can occur.
In SMAW, what is 'undercut' and what typically causes it?
Answer: A groove melted into the base metal along the weld toe, caused by excessive amperage or incorrect electrode angle
Undercut is a groove or channel melted into the base metal at the weld toe that is not filled by weld metal. It is caused by excessive current, incorrect electrode angle, or too fast a travel speed. Undercut reduces the cross-sectional thickness and acts as a stress riser.
What is the significance of the 'H4' or 'H8' suffix on a low-hydrogen electrode designation such as E7018-H4?
Answer: The maximum diffusible hydrogen content in mL per 100g of deposited weld metal
The H-designator indicates the maximum diffusible hydrogen content: H4 means ≤4 mL/100g, H8 means ≤8 mL/100g, and H16 means ≤16 mL/100g. Lower hydrogen content reduces the risk of hydrogen-induced cracking.
When making multiple passes in a groove weld, what is the purpose of the stringer bead technique compared to weaving?
Answer: Stringer beads minimize heat input and HAZ size, providing better mechanical properties in high-restraint joints
Stringer beads involve minimal side-to-side motion and result in lower heat input per pass. This reduces HAZ size, minimizes distortion, and is preferred for high-strength or hardenable steels. Many WPS documents specify stringer beads to control heat input.
What does the term 'deposition rate' refer to in SMAW welding?
Answer: The weight of weld metal deposited per unit of time (kg/hr)
Deposition rate is the weight of weld metal deposited per unit of time, expressed in kg/hr or lb/hr. It is affected by amperage, electrode diameter, electrode type, and welding position. Higher deposition rates increase productivity.
What is the correct way to handle and store E7018 electrodes on a jobsite according to CSA W48 requirements?
Answer: Keep in a heated rod oven at 120–150°C; once removed, use within 4 hours or return to oven for reconditioning
CSA W48 specifies that low-hydrogen electrodes must be stored in holding ovens at 120–150°C. After removal, they should be used within 4 hours (or as specified by the WPS). Electrodes can be reconditioned (rebaked) a limited number of times if they have been exposed to moisture.
How this page was made: written with AI tools and published by Nathan Beja, founder of Practice Test Geeks, who is responsible for its content. Exam facts are checked against the official sources listed below. Not reviewed by a subject-matter expert. Editorial policy
Sources & references
Exam facts on this page (fees, format, dates, passing scores) are checked against these official sources; the date is our last check. Editorial policy
- red-seal.ca — Exam format, exam information · verified Nov 2026
- skilledtradesontario.ca — Passing score, score release, time limit, renewal, score validity, eligibility, retake fee, test delivery, fees, retake policy · verified Nov 2026