← All 456A Flashcard Decks

SMAW (Shielded Metal Arc Welding) Flashcards

6 cards from real 456A practice questions. Tap to flip, then mark Knew It or Still Learning — missed cards come back until you master them.

Read the first 6 SMAW (Shielded Metal Arc Welding) flashcards as text
  1. What is the purpose of the flux coating on a SMAW electrode?

    Answer: Provides shielding gas and slag to protect the weld pool, stabilizes the arc, and adds alloying elements

    The flux coating on a SMAW electrode serves multiple functions: it generates shielding gases (CO2, CO) to protect the molten pool from atmospheric contamination, forms slag to protect the solidifying weld, stabilizes the arc, and can introduce alloying elements into the weld metal.

  2. When welding with E7018 electrodes, what defect is most likely if the electrodes have absorbed moisture?

    Answer: Hydrogen-induced cracking (underbead cracking)

    Moisture in low-hydrogen electrodes decomposes in the arc and introduces hydrogen into the weld metal. This hydrogen can diffuse to stress concentration points and cause hydrogen-induced cracking (HIC), also known as cold cracking or underbead cracking.

  3. What is the correct technique for striking an arc with a SMAW electrode?

    Answer: Scratch or tap the electrode on the base metal and quickly establish the correct arc length

    The scratch or tap method is used to initiate the SMAW arc. The electrode is moved across the base metal like striking a match (scratch) or briefly touched and lifted (tap). The arc length should be established quickly to prevent electrode sticking.

  4. What does arc blow refer to in SMAW welding?

    Answer: Deflection of the arc from its intended path due to magnetic fields

    Arc blow is the deflection of the welding arc caused by magnetic fields in the workpiece. It is most common when welding DC on ferromagnetic materials near the ends of joints or in corners. It can cause poor fusion and uneven bead profiles.

  5. Which of the following is a remedy for arc blow during SMAW?

    Answer: Switch from DC to AC current

    Switching from DC to AC eliminates arc blow because AC current alternates direction, preventing the buildup of a sustained magnetic field in the workpiece. Other remedies include repositioning the work lead, angling the electrode, or welding toward the work lead.

  6. What is the recommended arc length for most SMAW electrodes?

    Answer: Approximately equal to the diameter of the electrode core wire

    The correct arc length for SMAW is approximately equal to the diameter of the electrode core wire. Too short an arc causes sticking; too long an arc causes excessive spatter, porosity, and loss of penetration.

How this page was made: written with AI tools and published by Nathan Beja, founder of Practice Test Geeks, who is responsible for its content. Exam facts are checked against the official sources listed below. Not reviewed by a subject-matter expert. Editorial policy

Sources & references

Exam facts on this page (fees, format, dates, passing scores) are checked against these official sources; the date is our last check. Editorial policy

  1. red-seal.ca — Exam format, exam information · verified Nov 2026
  2. skilledtradesontario.ca — Passing score, score release, time limit, renewal, score validity, eligibility, retake fee, test delivery, fees, retake policy · verified Nov 2026