Blueprint Reading, Weld Symbols & Joint Preparation Flashcards
6 cards from real 456A practice questions. Tap to flip, then mark Knew It or Still Learning — missed cards come back until you master them.
Read the first 6 Blueprint Reading, Weld Symbols & Joint Preparation flashcards as text
On a weld symbol, on which side of the reference line is a weld symbol placed to indicate the 'arrow side' of the joint?
Answer: Below the reference line
According to AWS A2.4 (and the equivalent CSA standard used in Canada), weld symbols placed below the reference line indicate welding on the arrow side of the joint (the side the arrow points to). Symbols placed above the line indicate the other side. This convention is consistent throughout all standard weld symbols.
What does a weld symbol with a circle at the junction of the arrow and reference line indicate?
Answer: Weld all around the joint
A small circle at the junction of the arrow and reference line is the 'weld all around' symbol. It indicates that the weld is to be made completely around the joint perimeter. It is commonly used for tube-to-plate connections, pipe attachments, and structural sections where a continuous seal weld is required.
What does a filled (solid) flag at the junction of the reference line and arrow indicate on a weld symbol?
Answer: Field weld — the weld is to be made at the installation site, not in the fabrication shop
A solid (filled) flag at the arrow-reference line junction is the field weld symbol. It indicates that the weld is not to be made in the fabrication shop but at the job site during erection or installation. This is important for shipping logistics, inspection scheduling, and welding procedure applicability.
On a fillet weld symbol, where is the weld size (leg length) shown?
Answer: To the left of the weld symbol
The weld size (leg length in mm) for a fillet weld is written to the left of the fillet weld symbol. The length of the weld (if specified) is written to the right of the symbol. Both values appear on the same side of the reference line as the symbol (arrow side below, other side above).
What is the meaning of the number in parentheses on a groove weld symbol, such as a V-groove with (5) written in it?
Answer: The root opening (gap between the parts) in millimetres
A number in parentheses within a groove weld symbol represents the root opening (the gap at the root of the joint) in millimetres. This is a critical dimension for welding procedure setup, affecting root pass penetration. It is distinct from the groove angle (shown outside the symbol) and the weld depth.
What does 'CJP' written on a weld symbol in a drawing note indicate?
Answer: Complete Joint Penetration — the weld must fuse through the full thickness of the joint
CJP stands for Complete Joint Penetration. It specifies that the weld must achieve full fusion through the entire joint thickness, from root to face. CJP welds are required for high-stress joints (moment connections, pressure boundaries) and must be supported by a qualified WPS. They require back gouging and a back weld, or a backing bar, to achieve the required root penetration.
How this page was made: written with AI tools and published by Nathan Beja, founder of Practice Test Geeks, who is responsible for its content. Exam facts are checked against the official sources listed below. Not reviewed by a subject-matter expert. Editorial policy
Sources & references
Exam facts on this page (fees, format, dates, passing scores) are checked against these official sources; the date is our last check. Editorial policy
- red-seal.ca — Exam format, exam information · verified Nov 2026
- skilledtradesontario.ca — Passing score, score release, time limit, renewal, score validity, eligibility, retake fee, test delivery, fees, retake policy · verified Nov 2026